FIGURE 1: SCHEMATIC DIAGRAM TABLE 1: ELECTRICAL SPECIFICATIONS AT 25 OC PARAMETER MIN. TURNS RATIO'S: 1-3 : 6-4 ------- PRIMARY INDUCTANCE (6-4) VOLTAGE = 0.200Vrms @ 100KHz 785 DCR EACH WINDING -------- SPEC LIMITS TYP. MAX. UNITS 1:1 -------- + 2% -------- -------- Hy 1 SECONDARY -------- 0.6 6 PRIMARY Ohm 4 3 LEAKAGE INDUCTANCE (6-4) -------- 0.50 -------- Hy HI-POT: BETWEEN PRI & SEC 500 -------- -------- Vdc FIGURE 2: PHYSICAL DIMENSIONS IN INCHES, (mm) FIGURE 3: PCB LAYOUT 6 5 4 .059 (1.5) P PMGD-64 M XXXX .043 (1.1) PIN #1 (Dot) 1 2 .22 (5.6) .073 (1.85) 3 .264 (6.70) MAX .250 (6.35) MAX .010 (0.25) .024 (0.6) .334 (8.5) MAX UNLESS OTHERW ISE SPECIFIED DIMENSIONS ARE IN INCHES DIMENSIONAL TOLERANCES ARE: DECIMALS ANGLES .XX + .04 + 0 O 30' .XXX + .020 DO NOT SCALE DRAWING REV. DESCRIPTION OF CHANGES BY 10/30/12 ORIGINAL RELEASE PP GATE DRIVE TRANSFORMER CONTROL DRAWING PREMIER P/N: PMGD-64 REVISION: 10/30/12 DRAWN BY: PETER PHAM REF: SCALE: NONE SHEET: 1 OF 1