FIGURE 1: SCHEMATIC DIAGRAM TABLE 1: ELECTRICAL SPECIFICATIONS AT 25 OC MIN. SPEC LIMITS TYP. MAX. UNITS 1 -------- 1CT:5CT -------- PRIMARY INDUCTANCE (TIE 2-3) VOLTAGE = 0.200Vrms @ 100KHz 160 PRIMARY DCR (1-2) 0.5 -------- -------- Ohm SECONDARY DCR (5-6) 4.8 -------- -------- Ohm HI-POT: BETWEEN ANY TWO WINDINGS -------- 1800 -------- -------- -------- 8 + 3% Hy PRIMARY TURNS RATIO'S: PRI : SEC #5 2 3 7 6 4 5 SECONDARY PARAMETER Vdc FIGURE 2: PHYSICAL DIMENSIONS IN INCHES, (mm) 8 6 7 5 FIGURE 3: PCB LAYOUT .50 (12.7) .075 (1.90) .100 (2.54) WHITE DOT DENOTES PIN #1 1 2 3 4 .45 (11.43) MAX 0.50 (1.27) 8-PL P PMGD-60 M XXXX .21 (5.3) MAX .100 (2.54) .480 (12.2) UNLESS OTHERW ISE SPECIFIED DIMENSIONS ARE IN INCHES DIMENSIONAL TOLERANCES ARE: DECIMALS ANGLES .XX + .04 + 0 O 30' .XXX + .020 DO NOT SCALE DRAWING REV. DESCRIPTION OF CHANGES BY 03/01/04 ORIGINAL RELEASE PP GATE DRIVE TRANSFORMER CONTROL DRAWING PREMIER P/N: PMGD-60 REVISION: 03/01/04 DRAWN BY: PETER PHAM REF: SCALE: NONE SHEET: 1 OF 2