FIGURE 1: SCHEMATIC DIAGRAM TABLE 1: ELECTRICAL SPECIFICATIONS AT 25 OC PARAMETER MIN. TURNS RATIO'S: 1-3 : 4-6 ------- SPEC LIMITS TYP. MAX. UNITS 1 1:1 -------- + 2% -------- Hy PRIMARY INDUCTANCE (1-3) VOLTAGE = 0.200Vrms @ 100KHz 330 -------- DCR EACH WINDING -------- -------- LEAKAGE INDUCTANCE -------- 0.60 -------- Hy HI-POT: BETWEEN PRI & SEC 1500 -------- -------- Vdc 1.0 6 PRIMARY Ohm SECONDARY 4 3 FIGURE 2: PHYSICAL DIMENSIONS IN INCHES, (mm) 6 P M 5 4 FIGURE 3: PCB LAYOUT .059 (1.5) PMGD-59 XXXX .043 (1.1) PIN #1 (Dot) 1 2 .22 (5.6) .073 (1.85) 3 .270 (6.86) MAX .250 (6.35) MAX .010 (0.25) .024 (0.6) .334 (8.5) MAX UNLESS OTHERW ISE SPECIFIED DIMENSIONS ARE IN INCHES DIMENSIONAL TOLERANCES ARE: DECIMALS ANGLES .XX + .04 + 0 O 30' .XXX + .020 DO NOT SCALE DRAWING REV. DESCRIPTION OF CHANGES BY 11/04/07 12/13/07 ORIGINAL RELEASE CHANGED DIMENSIONS PP HH 04/06/09 \07/27/09 REMOVE THE CLIP ADD DOUPLE VARNISH PP PP GATE DRIVE TRANSFORMER CONTROL DRAWING PREMIER P/N: PMGD-59 REVISION: 07/27/09 DRAWN BY: PETER PHAM REF: SCALE: NONE SHEET: 1 OF 1