MAB46 Product profile Single Phase Ultra Low VF Schottky Bridge Rectifier General description Schottky Rectifiers 4 Amp 60V Features • Ideal for printed circuit board. • High current capability • Reliable low cost construction utilizing molded plastic technique. • Low forward voltage drop • Low power loss, high efficiency • High surge current capability • High temperature soldering guaranteed Mechanical data 260°C /10sec/0.375" lead length at 5 lbs tension • Case: Molded plastic Small size, simple installation. Epoxy: UL 94V-0 rate flame retardant Lead: MIL-STD- 202E, Method 208 guaranteed Polarity: As marked Maximum Ratings (Tc=25°C unless otherwise noted) Parameter Symbol MAB46 Unit Maximum repetitive peak reverse voltage VRRM 60 V RMS Voltage (Max.) VRMS 50 V Working peak reverse voltage VRWM 60 V Total Device IF(AV) 4 A 8.3ms single half sine-wave superimposed IFSM 60 A TJ -55 to +150 °C TSTG -55 to +150 °C Maximum average forward rectified current Peak forward surge current on rated load (JEDEC Method) Operating junction temperature range Storage temperature range THERMAL CHARACTERISTICS Parameter Symbol Value Unit Typical thermal resistance RθJA 75 °C/W Notes: (1) Pulse test: 300 μs pulse width, 1 % duty cycle (2) Pulse test: Pulse width ≤ 40 ms Publication Order Number: MAB46 ©Bruckewell Technology Corporation Rev. A -2014 MAB46 Electrical characteristics (Tc=25°C unless otherwise noted) OFF CHARACTERISTICS Parameter Symbol Value Unit Typical Max 0.60 0.66 0.56 0.61 Instantaneous forward voltage at IF=4A, Tj=25°C VF at IF=4A, Tj=125°C Maximum reverse current Tj=25°C V 200 u'A 50 m'A 205 pF IR at working peak reverse voltage Tj=125°C Junction Capacitance @ DC 5V CJ DEVICE MARK MAB46 Publication Order Number: MAB46 ©Bruckewell Technology Corporation Rev. A -2014 MAB46 Characteristic Curves Publication Order Number: MAB46 ©Bruckewell Technology Corporation Rev. A -2014 MAB46 Disclaimer ALL PRODUCT, PRODUCT SPECIFICATIONS AND DATA ARE SUBJECT TO CHANGE WITHOUT NOTICE TO IMPROVE RELIABILITY, FUNCTION OR DESIGN OR OTHERWISE. Bruckewell Technology Inc., its affiliates, agents, and employees, and all persons acting on its or their behalf (collectively, “Bruckewell”), disclaim any and all liability for any errors, inaccuracies or incompleteness contained in any datasheet or in any other disclosure relating to any product. Bruckewell makes no warranty, representation or guarantee regarding the suitability of the products for any particular purpose or the continuing production of any product. To the maximum extent permitted by applicable law, Bruckewell disclaims (i) Any and all liability arising out of the application or use of any product. (ii) Any and all liability, including without limitation special, consequential or incidental damages. (iii) Any and all implied warranties, including warranties of fitness for particular purpose, non-infringement and merchantability. Statements regarding the suitability of products for certain types of applications are based on Bruckewell’s knowledge of typical requirements that are often placed on Bruckewell products in generic applications. Such statements are not binding statements about the suitability of products for a particular application. It is the customer’s responsibility to validate that a particular product with the properties described in the product specification is suitable for use in a particular application. Parameters provided in datasheets and/or specifications may vary in different applications and performance may vary over time. Product specifications do not expand or otherwise modify Bruckewell’s terms and conditions of purchase, including but not limited to the warranty expressed therein. Publication Order Number: MAB46 ©Bruckewell Technology Corporation Rev. A -2014