CLR Series Thick Film Chip Resistor • • • • • Resistances from 1 Ohm to 100 MOhms Power Rating 0.05 to 1 Watt Resistance Tolerances to ± 1% TCR’s to ±100 ppm/°C Sizes: 0201 / 0402 / 0603 / 0805 / 1206 / 1210 / 2010 and 2512 SPECIFICATIONS Type CLR0201 CLR0402 CLR0603 CLR0805 CLR1206 CLR1210 CLR2010 CLR2512 Power Rating (W) at 70°C 0.050 0.063 0.100 0.125 0.250 0.333 0.750 1.000 Resistance Range (Ω) (1% - E24 and E96) (5% - E24) 1 to 10M 1 to 100M 1 to 100M 1 to 100M 1 to 100M 1 to 39M 1 to 100M 1 to 100M 1% / 5% Tolerances Temperature Coefficient 200PPM Max. Operating Voltage (V) 25 50 75 150 200 200 200 250 Max. Overload Voltage (V) 50 100 150 300 400 400 400 500 Packaging (pcs) Tape and Reel 1 Ohm - 9.76 Ohm (200PPM) / 100 Ohm - 1M (100PPM) / 1.1M - 10M (200PPM) 10,000 5,000 4,000 Test Specification Test Method Temperature Coefficient of Resistance see above JIS-C-5202 5.2 / IEC 60115-1 4.8 +25/-55/+25/+125, +155/+25°C Thermal Shock ±(1.0%+0.05Ω) MIL-STD-202F, Method 107 -55°C~125,155°C,5 cycles Short Time Overload ±(2.0%+0.05Ω) MIL-R-55342D 4.7.5 RCWV*2.5 or Max Overloading Voltage, 5 seconds High Temperature Exposure ±(2.0%+0.05Ω) MIL-R-55342D 4.7.6 1000 hours @ +125°C without load Load Life ±(3.0%+0.05Ω) MIL-STD-202F M108 RCWV, 70°C, 1.5 hours on, 0.5 hours off total 1000~1048 hours Resistance to Soldering Heat ±(1.0%+0.05Ω) MIL-R-55342D 4.7.7 260±5°C, 10±1seconds Moisture Resistance ±(2.0%+0.05Ω) MIL-STD-202F, Method 103 40°C, 90~95%RH, 1000 hours Low Temperature Operation ±(1.0%+0.05Ω) MIL-R-55342D 4.7.4 1hour, -55°C, followed by 45 minutes of RCWV Bending Strength ±(1.0%+0.05Ω) JIS-C-5202 6.1.4 5 mm deflection in either direction, 10 seconds Solderability 95% min coverage MIL-STD-202F-Method 208H 235±5°C,2±0.5seconds Ordering Information Part Description: Part Type - Resistance - Tolerance - TCR - Packaging Example: CLR 2010 10 Ohms 1% (Note: if no TCR is specified: The highest value will be supplied) CLR Series Thick Film Chip Resistor