SURFACE MOUNT THICK FILM RESISTOR NETWORK RN16 1/16W Rated Saves placement time -55°C - 125°C Industry standard size OUTLINE DRAWING SPECIFICATION Power rating at 70° Operating Temp. Range Derated at zero load at Maximum Working Voltage Maximum Overload Voltage Resistance Range Temperature Coefficient Resistance Tolerance 0.5±0.15 1/16W -55°C to +125°C +125°C 50v 100v 10Ω - 1M ±200ppm/°C ±5% and ±1% 1.6±0.2 0.5±0.15 0.3±0.15 0.8±0.05 0.5±0.1 3.20±0.2 0.3±0.15 0.8±0.05 SECTION 4 Test Method Temperature Coefficient Thermal Shock Low Temperature Operation Short Time Overload High Temperature Exposure Resistance to Soldering Heat Moisture Resistance Life Solderability Bending Strength MIL-STD-202F, Method 304 —55°C to + 125°C MIL-STD-202F, Method 107 5 cycles, —55°C to +125°C MIL-R-55342D, Para.4.7.4 1 hour at —65°C followed by 45 minutes RCWV MIL-R-55342D, Para.4.7.5 2.5 times RCWV for 5 seconds MIL-R-55342D, Para.4.7.6 125°C for 100 hours MIL-R-55342D, Para.4.7.7 Soldered to test board at 260°C for 10 secs MIL-STD-202F, METHOD 106 10 cycles. Total 240 hours MIL-STD-202F, Method 108A 1000 hours at 70°C RCWV intermittent MIL-STD-202F, Method 208 260°C for 10 seconds coverage JIS-C-5202, Para.6.1.4 Unit mounted in centre of 90mm board length deflected 5mm in either direction for 10 seconds 0.5±0.1 1.6±0.2 0.3±0.15 3.20±0.2 ENVIRONMENTAL CHARACTERISTICS Performance Test Dimensions in mm 0.3±0.15 SCHEMATICS n=4 Appraise n=4 ±200ppm/°C ±(1%+0.05Ω) ±(1%+0.05Ω) R1 ±(1%+0.05Ω) R1 R2 R2 Rn Rn ±(1%+0.05Ω) ±(1%+0.05Ω) ±(2%+0.05Ω) ±(2%+0.05Ω) 95% min. ±(1%+0.05Ω) ORDERING INFORMATION RN16 4 102 J Series No. of Resistors Value Tolerance J = 5% F = 1% 142 Fax: 01371 875075 www.dubilier.co.uk Tel: 01371 875758