2015-2장 2015.1.20 03:35 PM 페이지40 태산아이인쇄그룹(국) 2261-2488 2400DPI 175LPI CONDUCTIVE POLYMER ALUMINUM ELECTROLYTIC CAPACITORS FH Chip type, Large Capacitance, Low ESR Series Hi-CAP ・Large capacitance, Low ESR than FA Series ・Complied to the RoHS directive Item Characteristics Operating temperature range Leakage current max. Capacitance tolerance Dissipation factor max. ESR -55 ~ +105° C Less than or equal to the value of Table1 ±20% at 120Hz, 20° C Less than or equal to the value of Table1 Less than or equal to the value of Table1 Z+105° C / Z+20° C 0.75 ~ 1.25 Z-55° C / Z+20° C 0.75 ~ 1.25 Temperature characteristics (Impedance ratio at 100kHz) Load life (after application of the rated voltage for 2000 hours at 105° C) Leakage current Capacitance change ESR tanδ Less than specified value Within ±20% of initial value Less than 150% of specified value Less than 150% of specified value Resistance to soldering heat (Refer to Page 37 for soldering recommendation) Leakage current Capacitance change tanδ Less than specified value Within ±10% of initial value Less than 130% of specified value In case of some problems for measured values, measure after applying rated voltage for 120 minutes at 105° C. ● DRAWING Unit : mm < Dimensions > ＋ A±0.2 C±0.2 A±0.2 E B±0.2 ØD±0.5 0.3 max. Positive 0.5 max. Plastic plateform L±0.3 － R Negative < Marking > Capacitance Capacitance Series Code ＋ 10H Lot No. ※Voltage 6.3V is 6 － ※Voltage 6.3V is 6 － Negative Polarity (Ø5) Series Code“H” 40 Lot No. 10FH ＋ Series Code Negative Polarity (Ø6.3, Ø8, Ø10) ● PART NUMBER SYSTEM (See Page 52) Size ØD L B C E A R 5×5.9 5 5.9 5.3 5.3 1.4 2.2 0.5~0.8 6.3×5.9 6.3 5.9 6.6 6.6 2.2 2.45 0.5~0.8 8×6.9 8 6.9 8.3 8.3 3.2 2.9 0.5~0.8 8×11.9 8 11.9 8.3 8.3 3.2 2.9 0.8~1.1 10×12.6 10 12.6 10.3 10.3 4.6 3.2 0.8~1.1 2015-2장 2015.1.20 03:35 PM 페이지41 태산아이인쇄그룹(국) 2261-2488 2400DPI 175LPI CONDUCTIVE POLYMER ALUMINUM ELECTROLYTIC CAPACITORS FH Series ● Table 1. FH(SMD type) Series Characteristics List μF 2.5 2.5 2.5 2.5 2.5 2.5 2.5 4 4 4 4 4 4 6.3 6.3 6.3 6.3 6.3 10 10 10 16 16 16 180 330 390 680 820 1500 2700 150 330 560 560 1200 1500 100 220 330 390 820 68 120 270 39 68 120 Size ØD(mm) L(mm) 5 6.3 6.3 8 8 8 10 5 6.3 8 8 8 8 5 6.3 6.3 8 8 5 6.3 8 5 6.3 8 5.9 5.9 5.9 6.9 11.9 11.9 12.6 5.9 5.9 6.9 11.9 11.9 11.9 5.9 5.9 5.9 6.9 11.9 5.9 5.9 6.9 5.9 5.9 6.9 ESR(mΩ)max. 100kHz~300kHz Ripple current (mA rms) at 105°C, 100kHz Dissipation factor at 120Hz (max.) Leakage Current (μA) (max.) after 2 minutes 24 15 25 20 9 10 12 23 21 22 9 12 12 25 15 17 22 12 30 27 22 35 30 27 2200 3160 2410 3370 5380 5150 5080 2240 2630 3220 5380 4700 4700 2150 3110 3390 3220 4700 1970 2320 3220 1820 2200 2900 0.12 0.12 0.12 0.12 0.15 0.15 0.15 0.12 0.12 0.12 0.15 0.15 0.15 0.12 0.12 0.12 0.12 0.15 0.12 0.12 0.12 0.12 0.12 0.12 300 500 300 500 500 750 1350 300 300 500 500 960 1200 300 300 416 491 1033 300 300 500 300 300 500 SOLID TYPES WV ● FREQUENCY COEFFICIENT OF PERMISSIBLE RIPPLE CURRENT Frequency 120Hz 1kHz 10kHz 100~500kHz Coefficient 0.05 0.3 0.7 1 41