2015-3장 2015.1.20 03:36 PM 페이지69 태산아이인쇄그룹(국) 2261-2488 2400DPI 175LPI SURFACE MOUNT ALUMINUM ELECTROLYTIC CAPACITORS CK Chip type, Low Impedance, High CV Series Low Impedance Solvent Proof ・Chip type, low impedance temperature range up to 105° C ・Designed for surface mounting on high density PC board ・Applicable to automatic insertion machine using carrier tape ・Complied to the RoHS directive Item Operating temperature range Leakage current max. Capacitance tolerance Characteristics -55 ~ +105° C I = 0.01CV or 3μ A whichever is greater (after 2 minutes) ±20% at 120Hz, 20° C Dissipation factor max. (at 120Hz, 20° C) WV tanδ Low temperature characteristics (Impedance ratio at 120Hz) WV Z-25° C/Z+20° C Z-55° C/Z+20° C Load life (after application of the rated voltage for 2000 hours at 105° C) 6.3 0.24 Leakage current Capacitance change tanδ 10 0.19 6.3 2 3 16 0.16 25 0.14 10 2 3 35 0.12 16 2 3 50 0.12 25 2 3 63 0.10 35 2 3 80 0.10 100 0.10 50 2 3 63~100 3 4 Less than specified value Within ±25% of initial value Less than 200% of specified value After 1000 hours no load test, leakage current, capacitance and tanδare same as load life value. The measurement shall be performed at 20° C by the KS C IEC 60384 - 4 Resistance to soldering heat The following specifications shall be satisfied when the capacitors are restored to 20° C after exposing them at 250° C for 10 seconds. Less than specified value Leakage current Within ±10% of initial value Capacitance change Less than specified value tanδ ● DRAWING Unit : mm -Series code of CK is “K” K (Ø6.3,Ø8×6.2) ØD×L 6.3×5.8 6.3×7.7 8×6.2 8×10 10×10 12.5×13.5 A B C 2.4 6.6 6.6 2.4 6.6 6.6 3.3 8.3 8.3 2.9 8.3 8.3 3.2 10.3 10.3 4.6 12.8 12.8 E 2.2 2.2 2.3 3.1 4.5 4.5 R 0.5~0.8 0.5~0.8 0.5~0.8 0.8~1.1 0.8~1.1 0.8~1.4 ※Voltage mark for 6.3V is 6 K (Ø8×10, Ø10×10) (Ø12.5×13.5) 69 CHIP TYPES Shelf life (at 105° C) 2015-3장 2015.1.20 03:36 PM 페이지70 태산아이인쇄그룹(국) 2261-2488 2400DPI 175LPI SURFACE MOUNT ALUMINUM ELECTROLYTIC CAPACITORS CK series ● DIMENSIONS & MAXIMUM PERMISSIBLE RIPPLE CURRENT WV μF 6.3 10 16 25 35 50 10 6.3×5.8 1.0 165 15 6.3×5.8 1.0 165 22 6.3×5.8 1.0 165 6.3×7.7 0.68 280 6.3×5.8 0.44 230 6.3×5.8 0.44 230 6.3×5.8 0.44 230 33 8×6.2 0.63 300 6.3×7.7 0.68 280 6.3×5.8 0.44 230 6.3×5.8 0.44 230 6.3×5.8 0.44 230 6.3×5.8 0.44 230 47 8×6.2 0.63 300 8×10 0.34 450 6.3×7.7 0.34 280 6.3×5.8 0.44 230 6.3×5.8 0.44 230 6.3×5.8 0.44 230 6.3×5.8 0.44 230 68 8×6.2 0.26 300 8×10 0.17 450 10×10 0.18 670 8×10 0.17 450 6.3×7.7 0.34 280 6.3×5.8 0.44 230 6.3×5.8 0.44 230 6.3×5.8 0.44 230 100 8×6.2 0.26 300 8×10 0.17 450 8×10 0.17 450 10×10 0.09 670 6.3×7.7 0.34 280 6.3×5.8 0.44 230 6.3×5.8 0.44 230 150 8×6.2 0.26 300 6.3×7.7 0.34 280 6.3×7.7 0.34 280 6.3×5.8 0.44 230 220 8×6.2 0.26 300 8×6.2 0.26 300 8×10 0.17 450 0.17 450 10×10 0.15 670 8×10 0.17 450 10×10 0.09 670 6.3×7.7 0.34 280 330 8×6.2 0.26 300 470 8×10 0.17 450 680 8×10 0.17 450 10×10 0.09 670 1000 10×10 0.09 670 1500 10×10 0.09 670 WV μF 10 22 33 47 68 100 150 220 8×10 80 63 6.3×5.8 6.3×7.7 8×10 8×10 10×10 10×10 12.5×13.5 12.5×13.5 2.8 2.1 0.9 0.9 0.5 0.5 0.32 0.32 80 120 250 250 400 400 800 800 6.3×7.7 8×10 8×10 10×10 12.5×13.5 12.5×13.5 12.5×13.5 100 2.4 1.3 1.3 1.2 0.8 0.8 0.8 60 130 130 200 500 500 500 8×10 10×10 12.5×13.5 12.5×13.5 1.3 1.2 0.8 0.8 130 200 500 500 Ripple current (mA r ms) at 105° C, 100kHz Impedance (Ω) at 20° C, 100kHz Case size ØD X L (mm) ● FREQUENCY COEFFICIENT OF PERMISSIBLE RIPPLE CURRENT 70 Frequency 50Hz 120Hz 300Hz 1kHz 10kHz≦ Coefficient 0.35 0.5 0.64 0.83 1.00