Mini-Circuits Environmental Specifications ENV65 All Mini-Circuits products are manufactured under exacting quality assurance and control standards, and are capable of meeting published specifications after being subjected to any or all of the following physical and environmental test. Specification Test/Inspection Condition Reference/Spec Operating Temperature -55° to 85°C Ambient Environment Individual Model Data Sheet Storage Temperature -55° to 100° C Ambient Environment Individual Model Data Sheet Humidity 90 to 95% RH, 240 hours, 50°C MIL-STD-202, Method 103, Condition A, Except 50°C and end-point electrical test done within 12 hours Thermal Shock -55° to 100°C, 100 cycles MIL-STD-202, Method 107, Condition A-3, except +100°C Solder Reflow Heat Sn-Pb Eutectic Process: 225°C peak Pb-Free Process, 245°C peak J-STD-020, Table 4-1, 4-2 and 5-2, Figure 5-1 Solderability 10X Magnification J-STD-002, Para 4.2.5, Test S, 95% Coverage Vibration (High Frequency) 20g peak, 20-2000 Hz, 4 times in each of three axes (total 12) MIL-STD-883, Method 2007.3, Condition A Mechanical Shock 50g, 11 ms, 1/2-sine, 18 shocks: 3 each direction, each of 3 axes MIL-STD-202, Method 213, Condition A Marking Resistance to Solvents Isopropyl alcohol + mineral spirits at 25°C; terpene defluxer at 25°C; distilled water + proylene glycol monomethyl ether + monoethanolamine at 63°C to 70°C MIL-STD-202, Method 215 ENV65 Rev: OR 03/20/12 M136382 File: ENV65.pdf This document and its contents are the property of Mini-Circuits. Page: 1