LED760/940-04A TECHNICAL DATA Dual LED, 5 mm AlGaAs, GaAs Dual LED of LED760/940-04A consists of DDH AlGaAs and GaAs LEDs mounted on a lead frame with a clear epoxy lens. On forward bias it emits a band of visible light, which peaks 760nm and 940 at anode common. Specifications • • • • • Structure: AlGaAs (DDH structure) Peak Wavelength: typ. 760 nm / 940 nm Optical Ouput Power: typ. 15 mW / 14 mW Resin Material: Epoxy resin Solder: Lead free Absolute Maximum Ratings (Ta=25°C) Item Symbol Power Dissipation PD Forward Current IF Reverse Voltage VR Operating Temperature Topr Storage Temperature Tstg Soldering Temperature * Tsol * must be completed within 3 seconds Value 760mn 940nm 200 140 100 10 -30 … +80 -30 … +100 265 Unit mW mA V °C °C °C (Unit: mm) Electro-Optical Characteristics Item Forward Voltage Reverse Current Total Radiated Power Peak Wavelength Half Width Viewing Half Angle Symbol Condition VF IR PO λP Δλ Θ1/2 IF = 20 mA VR = 5 V IF = 20 mA IF = 20 mA IF = 20 mA IF = 20 mA Min. Typ. Max. 760nm 940nm 760nm 940nm 760nm 940nm 1.85 1.30 2.00 1.45 10 8.0 8.0 15.0 14.0 740 930 760 940 780 960 30 50 ±20 - Unit V µA mW nm nm deg. Total Radiated Power is measured by Photodyne #500 Notes • Do not view directly into the emitting area of the LED during operation! • The above specifications are for reference purpose only and subjected to change without prior notice. 29.08.2011 LED760/940-04A 1 of 3 Precaution for Use 1. Cautions • DO NOT look directly into the emitted light or look through the optical system. To prevent in adequate exposure of the radiation, wear protective glasses. 2. Lead Forming • When forming leads, the leads should be bent at a point at least 3 mm from the base of the lead. DO NOT use the base of the leadframe as a fulcrum during lead forming. • Lead forming should be done before soldering. • DO NOT apply any bending stress to the base of the lead. The stress to the base may damage the LED’s characteristics or it may break the LEDs. • When mounted the LEDs onto the printed circuit board, the holes on the circuit board should be exactly aligned with the leads of LEDs. If the LEDs are mounted with stress at the leads, it causes deterioration of the lead and it will degrade the LEDs. Recommended Land Layout (Unit: mm) 3. Soldering Conditions • Solder the LEDs no closer than 3 mm from the base of the lead. • DO NOT apply any stress to the lead particularly when heat. • The LEDs must not be reposition after soldering. • After soldering the LEDs, the lead should be protected from mechanical shock or vibration until the LEDs return to room temperature. • When it is necessary to clamp the LEDs to prevent soldering failure, it is important to minimize the mechanical stress on the LEDs. • Cut the LED leads at room temperature. Cutting the leads at high temperature may cause the failure of the LEDs. 29.08.2011 LED760/940-04A 2 of 3 Soldering Conditions 4. Static Electricity • The LEDs are very sensitive to Static Electricity and surge voltage. So it is recommended that a wrist band or an anti-electrostatic glove be used when handling the LEDs. • All devices, equipment and machinery must be grounded properly. It is recommended that precautions should be taken against surge voltage to the equipment that mounts the LEDs. 29.08.2011 LED760/940-04A 3 of 3