Part Number: XZM2ACR46W-9 SUBMINIATURE SOLID STATE LAMP PRELIMINARY SPEC Features Subminiature package. Z-bend lead. Long life-solid state reliability. Low package profile. Package : 1000pcs / reel. Moisture sensitivity level : level 3. RoHS compliant. Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ± 0.25(0.01") unless otherwise noted. 3.Specifications are subject to change without notice. Absolute Maximum Ratings (TA=25°C) M2ACR (AlInGaP) Unit Reverse Voltage VR 5 V Forward Current IF 30 mA Forward Current (Peak) 1/10 Duty Cycle 0.1ms Pulse Width iFS 150 mA Power Dissipation PT 84 mW Operating Temperature TA -40 ~ +85 Tstg -40 ~ +85 Storage Temperature Part Number XZM2ACR46W-9 Emitting Color Red Published Date : JAN 09,2009 Emitting Material AlInGaP °C Lens-color Water Clear Drawing No : XDSB2765 Operating Characteristics (TA=25°C) M2ACR (AlInGaP) Unit Forward Voltage (Typ.) (IF=20mA) VF 2.2 V Forward Voltage (Max.) (IF=20mA) VF 2.8 V Reverse Current (Max.) (VR=5V) IR 10 uA Wavelength of Peak Emission (Typ.) (IF=20mA) λP 640 nm Wavelength of Dominant Emission (Typ.) (IF=20mA) λD 630 nm Spectral Line Full Width At Half-Maximum (Typ.) (IF=20mA) Δλ 25 nm Capacitance (Typ.) (VF=0V, f=1MHz) C 27 pF Luminous Intensity (IF=20mA) mcd min. typ. 8000 14990 V1 Wavelength nm λP Viewing Angle 2 θ 1/2 640 20° Checked : Shin Chi P.1/4 Part Number: XZM2ACR46W-9 SUBMINIATURE SOLID STATE LAMP M2ACR Published Date : JAN 09,2009 Drawing No : XDSB2765 V1 Checked : Shin Chi P.2/4 Part Number: XZM2ACR46W-9 SUBMINIATURE SOLID STATE LAMP Reflow soldering is recommended and the soldering profile is shown below. Other soldering methods are not recommended as they might cause damage to the product. Recommended Soldering Pattern (Units : mm;Tolerance:± 0.1) The device has a single mounting surface. The device must be mounted according to the specifications. Tape Specification (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, Luminous intensity / luminous flux, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity / Luminous Flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. Published Date : JAN 09,2009 Drawing No : XDSB2765 V1 Checked : Shin Chi P.3/4 Part Number: XZM2ACR46W-9 SUBMINIATURE SOLID STATE LAMP PACKING & LABEL SPECIFICATIONS Published Date : JAN 09,2009 Drawing No : XDSB2765 XZM2ACR46W-9 V1 Checked : Shin Chi P.4/4