8 7 6 5 4 3 2 THE INFORMATION CONTAINED HEREIN IS THE EXCLUSIVE PROPERTY OF VIRGINIA PANEL CORP. AND IS SUBMITTED FOR USE BY THE CUSTOMER ONLY. THE DATA SHALL NOT BE DUPLICATED, USED, OR DISCLOSED IN WHOLE OR IN PART FOR ANY PURPOSE OTHER THAN TO MAINTAIN THE EQUIPMENT PROVIDED. DO NOT SCALE DRAWING 1 REVISIONS ZONE REV DESCRIPTION M ECN #6060 DATE APPROVED 6/11/15 JTD 535.56 21.08 D MICRO SWITCH LOCATION. SEE NOTES FOR WIRING INSTRUCTIONS. 482.60 19.00 D 430.10 16.93 6 244.40 9.62 144.78 5.70 33.53 1.32 HANDLE CAN BE LOOSENED AND ROTATED IN 90 DEGREE INCREMENTS. 362.79 14.28 45.21 1.78 C C 449.58 17.70 RUBBER FEET PATTERN 292.10 11.50 RUBBER FEET PATTERN A 6 IF KEYING IS REQUIRED USE VPC KEYING KIT PART NUMBER 310118112. SEE TABLE FOR KEYING OPTIONS. 5. RUBBER FEET MAY BE REMOVED AND RECEIVER SECURED DOWN TO A TABLE WITH 1/4-20 SCREWS. 4. WEIGHT: APROXIMATELY 20 POUNDS. ALUMINUM AND STEEL. 3. FOR DEEPER RACKS USE P/N 310113413, 1.5" RECEIVER EXTENSION KIT. 2. MICROSWITCH WIRES NOT SHOWN. COLOR CODE AS FOLLOWS: RED- NC WHITE- NO BLACK- COMMON 1 SOLIDWORKS DRAWING FILE B FOR APPLICATION, USE & CARE INFORMATION CONSULT VPC USERS GUIDE @WWW.VPC.COM. NOTES: 8 7 6 5 4 B CUSTOMER DRAWING - CUSTOMER DRAWING DIMENSIONS ARE SHOWN AS: [millimeters] INCHES CONTRACT NO. SIGNATURES DATE DR E. HUBBARD 1/05/05 CHK R. HERRON E. HUBBARD 1/05/05 REMOVE BURRS. BREAK SHARP EDGES. ENG MATERIAL PROD A VIRGINIA PANEL CORPORATION WWW.VPC.COM RECEIVER, G12, 12 MODULE WITH 15" PLATFORM, LH 5/5/04 ASSY FINISH QA SIZE D 18117 APPD 3 FSCM NO. SCALE: 2 1:4 DWG NO. 310104356 310104356 1/05/05 1 REV M SHEET 1 OF1