WPANT30086-S3A 2.45 GHz Wi-Fi Body-mount Antenna Description / Application This is a 2.45 GHz Wi-Fi / WLAN Body mount antenna. It is surface independent, which means it performs efficiently on metallic as well as non-metallic surfaces. Standard cable is 18’’ long 1.32mm OD micro coax and connector is SMA Male. Please contact [email protected] with your specific application requirements. Electrical Properties Operating Frequency Approximate Antenna Impedance [Ω] VSWR – Typical Peak Gain [dBi] (Typical) Efficiency [%] (Typical) Polarization Pattern Accepted Power [W] (Max) 2.4 – 2.5 GHz 50Ω < 2:1 ~ 2 dBi 60 – 70 % Linear Near Omni-directional 2 Watts Mechanical / Environmental Properties Antenna Dimensions Antenna Color Cable Connector Tape External Bottom Gasket Material Nut Torque for the Nut Antenna Plastic Radome Operating / Storage Temperature Environmental (for the complete antenna assembly, including the external foam gasket) Hazardous Materials **Height includes the 3M tape & foam gasket thickness. Rev: 3.0 Created on: January 03, 2014 1.5’’ Height** X 1.3’’ Base Dia Black (38mm X 32.3mm) 18’’ long 1.32mm OD Micro Co-ax Straight SMA Male Standard 3M 4920 double stick Standard 3M 6208 foam Standard Nylon M12 1.2 ABS + Polycarbonate o o -40 C to +90 C Salt Spray Resistant, Water Ingress Resistant, UV Resistant, Ageing Resistant, Meets standards for UL 94V-0 This antenna is built in accordance with: IP 67,66,65 NEMA 250-2008 ASTM G 85-2009 ASTM G 154-2006 RoHS Compliant Created by: MKS Approved by: BP Page | 1 Pictures of the Antenna Note: Mounting screw has two flat surfaces opposite to each other. Rev: 3.0 Created on: January 03, 2014 Created by: MKS Approved by: BP Page | 2 VSWR of the Antenna Rev: 3.0 Created on: January 03, 2014 Created by: MKS Approved by: BP Page | 3