WPANT30102-S1B 2.45 GHz Wi-Fi MIMO Body-mount Antenna Note: Prototypes shown. The actual antenna will be grey in color. Description / Application This is a Wi-Fi / WLAN MIMO Body mount antenna. It is surface independent, which means it performs efficiently on metallic as well as non-metallic surfaces. The recommended minimum spacing between the two elements is 70mm. Standard cable is 24’’ long 1.32mm OD micro coax and connector is RP - SMA Male. Please contact [email protected] with your specific application requirements. Electrical Properties Operating Frequency Approximate Antenna Impedance [Ω] VSWR – Typical 2.4 – 2.5 GHz 50Ω < 2:1 Peak Gain [dBi] (Typical) 2 to 3 dBi Efficiency [%] (Typical) 60 – 70 % Isolation [dB] (Typical) < -30 dB Polarization Pattern Linear Near Omni-directional Mechanical / Environmental Properties Antenna Dimensions Antenna Color Cable Connector Tape External Bottom Gasket Material Nut Torque for the Nut Antenna Plastic Radome Operating / Storage Temperature Environmental (for the complete antenna assembly, including the external foam gasket) Hazardous Materials **Height includes the 3M tape & foam gasket thickness. Rev: 1.0 Created on: February 18, 2014 1.5’’ Height** X 1.3’’ Base Dia Grey (38mm X 32.3mm) 24’’ long 1.32mm OD Micro Co-ax Reverse Polarity Straight SMA Male Standard 3M 4920 double stick Standard 3M 6208 foam Standard Nylon M12 1.2 ABS + Polycarbonate o o -40 C to +90 C Salt Spray Resistant, Water Ingress Resistant, UV Resistant, Ageing Resistant, Meets standards for UL 94V-0 This antenna is built in accordance with: IP 67,66,65 NEMA 250-2008 ASTM G 85-2009 ASTM G 154-2006 RoHS Compliant Created by: MKS Approved by: BP Page | 1 Pictures of the Antenna Note: Prototypes shown here. The actual antenna will be grey in color. Rev: 1.0 Created on: February 18, 2014 Created by: MKS Approved by: BP Page | 2 VSWR of the Single Element of the Antenna Rev: 1.0 Created on: February 18, 2014 Created by: MKS Approved by: BP Page | 3