Tfs90

Tfs90.doc
version 1.2
VI TELEFILTER
03.11.2003
Filter Specification
TFS 90
1/5
Measurement condition
Ambient temperature:
23 °C
Input power level:
0 dBm
Terminating impedances*
for input:
740 Ω ║ -2,2 pF
for output:
740 Ω ║ -2,2 pF
Characteristics
Remark:
Reference level for the relative attenuation arel of the TFS 90 is the minimum of the pass band attenuation amin. The minimum of the pass band
attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3
dB filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed on 90 MHz without tolerance. The given values for the
relative attenuation arel and for the group delay ripple have to be reached at the frequencies given below also if the centre frequency fc is shifted
due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc.
Data
typ. value
Insertion loss
(Reference level)
ae = amin
3,2
Nominal frequency
fN
-
Centre frequency
fc
fN
fN
fN
fN
fN
fN
fN
fN
fN
- 1000
- 940
- 880
- 400
- 120
+ 60
+ 120
+ 150
+ 400
kHz
kHz
kHz
kHz
kHz
kHz
kHz
kHz
kHz
...
...
...
...
...
...
...
...
...
fN
fN
fN
fN
fN
fN
fN
fN
fN
arel
- 940
- 880
- 400
- 120
60
+ 120
+ 150
+ 400
+ 1000
Group delay distortion
fN ± 11 kHz
dB
max. 4 dB
90,00
kHz
kHz
kHz
kHz
kHz
kHz
kHz
kHz
kHz
MHz
-
90,004 MHz
Pass band ripple
fN ± 13 kHz
Relative attenuation
fN ± 15 kHz
tolerance / limit
0,4
dB
max. 1,5 dB
0,6
dB
max. 3 dB
80
76
74
47...79
23
23
54...65
43
48
dB
dB
dB
dB
dB
dB
dB
dB
dB
min.
min.
min.
min.
min.
min.
min.
min.
min.
µs
max. 10 µs
50
70
50
40
15
15
40
30
40
dB
dB
dB
dB
dB
dB
dB
dB
dB
GDD
4
Operating temperature range
-
- 20 °C ... + 70 °C
Storage temperature range
-
- 40 °C ... + 85 °C
Temperature coefficient of frequency
Frequency inversion temperature
Permissible DC voltage
VDC
TCf**
-0,036 ppm/K²
-
25 °C
-
-
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as
max. 10 V
reference values only.
Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) ∆f(Hz) = TCf(ppm/K) x (T-T0)² x fTo(MHz).
Generated:
Checked / approved:
TeleFilter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-50 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Tfs90.doc
version 1.2
VI TELEFILTER
03.11.2003
Filter Specification
TFS 90
2/5
Construction, Pin Connection
(All dimensions in mm)
TFS 90
R26
Datecode
Pin 5
- Output
Pin 6
- Output RF Return
Pin 11
- Input
Pin 12
- Input RF Return
Pin 1,2,3,4,7,8,9,10
- Ground
Date code:
N
P
R
...
Year+week
2001
2002
2003
50 Ohm Test circuit 1
50 Ohm
L1
11
5
SAW
C1
12
L2
50 Ohm
C2
50 Ohm
C2
6
1, 2, 3, 4, 7, 8, 9, 10
50 Ohm Test circuit 2
50 Ohm
C1
11
5
SAW
L1
12
L2
6
1, 2, 3, 4, 7, 8, 9, 10
TeleFilter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-50 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Tfs90.doc
version 1.2
VI TELEFILTER
03.11.2003
Filter Specification
TFS 90
3/5
Stability Characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 18 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
4. Resistance to
solder heat (reflow):
reflow possible: twice max.;
for temperature conditions, please refer to the attached "Air reflow temperature conditions" on page 4;
Packing
Tape & Reel:
DIN IEC 286 – 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer
1700
min 300 mm
min 500 mm
min 300
mm
Tape (all dim ensions in mm )
W
: 24
± 0,3
Po
:
4
± 0,1
Do
:
1,5 + 0,1
E
:
1,75 ± 0,1
F
:
11,5 ± 0,1
G (min) :
0,60
P2
:
P1
:
D1(min) :
Ao
:
Bo
:
Ct
:
2
12
1,5
7,1
13,9
21,5
± 0,1
± 0,1
EMBOSSED CA RR IE R TA PE
Do
Po
P2
E
Ao
F
D1
Ct
W
Bo
G
± 0,2
± 0,2
± 0,1
P1
C OV ER TAP E
W2
Reel (all d imensions in mm):
A
:
W1
:
W2 (m ax) :
33 0
24 ,4 0 +2 ,0
30 ,4
N (m in)
:
60
C
:
13
+ 0 ,5 / -0 .2
A
C
N
W 1
The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape.
Markings on the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on its right.
TeleFilter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-50 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Tfs90.doc
version 1.2
VI TELEFILTER
03.11.2003
Filter Specification
TFS 90
4/5
Air reflow temperature conditions
1st and 2nd air reflow profile
Name:
Temperature:
Time:
pre-heating periods
150 °C - 170 °C
60 sec. - 90 sec.
main-heating periods
over 200 °C
20 sec. - 25 sec.
peak temperature
255 °C ± 5 °C
Chip-mount air reflow profile
260
240
220
200
temperature / °C
180
160
140
120
100
80
60
40
20
0
0
20
40
60
80
100
120
140
160
180
200
220
240
time / sec.
Table for temperature vs. time during the air reflow process
Tolerance of temperatures: ± 5 °C
time / sec.
0
10
20
30
40
50
60
70
80
90
100
110
120
130
temperature / °C
23
34
46
60
80
103
121
134
143
150
154
156
158
159
time / sec.
140
150
160
170
180
190
195
200
205
210
215
220
230
240
temperature / °C
160
161
164
170
180
205
230
255
230
205
180
165
140
120
TeleFilter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-50 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Tfs90.doc
version 1.2
VI TELEFILTER
Filter Specification
03.11.2003
TFS 90
5/5
History
Version
Reason of Changes
Name
Date
1.0
Generation of specification as a scaling of TFS85.
Change guaranteed attenuation at fN ± 60 kHz from 20 dB to 15 dB.
Dr. Wall
21.07.2000
1.1
Change package from 11*5 mm to 13*6,5 mm.
Remove requirements for intermodulation.
Dr. Wall
24.06.2003
1.2
Add terminating impedances and typical values.
Dr. Wall
03.11.2003
TeleFilter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-50 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.