VECTRON TFS225E

Filename: tfs225e.doc
version 1.2
VI TELEFILTER
Filter specification
25.04.2003
TFS 225E
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedances at fc *:
23
0
input:
output:
°C
dBm
940 Ω // -5,7 pF
940 Ω // -5,7 pF
Characteristics
Remark:
The reference level for the relative attenuation arel of TFS 225E is the minimum of the pass band attenuation amin. This value is defined as the
insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 1 dB filter attenuation level
relative to the insertion loss ae. The given values for the relative attenuation arel and the group delay ripple have to be reached at the frequencies
given below, even if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and
due to a production tolerance for the centre frequency fc.
Data
typ. value
Insertion loss
ae = amin
6,5
Nominal frequency
fN
-
Centre frequency
fc
225
Relative attenuation
arel
fN -
0,2 MHz ... fN +
0,2 MHz
fN ±
fN ±
0,6
1,2
1
1,8
7
1,2
1,8
1,8
7
1
fN +
fN +
kHz
MHz
MHz
MHz
MHz
... fN ±
... fN ±
... fN ... fN +
...
MHz
MHz
MHz
MHz
GHz
Group delay ripple in fN - 200 kHz ... fN + 200 kHz
0,5
dB
limit
min.
max.
4,5 dB
8
dB
225
MHz
MHz
-
dB
max.
1
dB
15
27
35
35
52
dB
dB
dB
dB
dB
min.
min.
min.
min.
min.
8
20
30
30
45
dB
dB
dB
dB
dB
85
ns
max. 350
ns
Operating temperature range
-
- 20 °C...+ 80 °C
Storage temperature range
-
- 35 °C.. + 85 °C
Temperature coefficient
TC **
- 0,04 ppm/K²
Frequency inversion temperature
T0
35
Input power level
-
-
°C
max. + 10
dBm
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as
reference values only. Should there be additional questions, do not hesitate to ask for an application note or contact our design team
**) ∆f(Hz) = TCf(ppm/K) x (T-T0)² x fTo(MHz)
generated:
checked / approved:
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs225e.doc
version 1.2
VI TELEFILTER
25.04.2003
Filter specification
TFS 225E
2/5
Construction and pin connection
(All dimensions in mm)
9
9,3 Max.
6
7
TFS 225 E
10
2
3
Date code
1,8 Max.
2,54 ±0,1
5
4
R17
1
1
2
3
4
5
6
7
8
9
10
date code
N
P
R
...
2,54 ±0,12,54 ±0,1
0,10
°
60 1
2
3
4
10
9
5
8
7
0,8
7,1
ground
ground
ground
output
output rf return
ground
ground
ground
input
input rf return
year + week
2001
2002
2003
2,8
5,0Max.
8
6
50 Ω test circuit
L1
L3
9
Input
50 Ohm
4
Output
50 Ohm
SAW
L2
L4
1, 2, 3, 5, 6, 7,8,10
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs225e.doc
version 1.2
VI TELEFILTER
25.04.2003
Filter specification
TFS 225E
3/5
Stability characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 18 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
4. Resistance to
solder heat (reflow):
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
Packing
Tape & Reel:
IEC 286 - 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer
Tape (all dimensions in mm)
W
:
16
± 0,3
Po
Do
E
:
4
± 0,1
:
:
1,5 + 0,1
1,75 ± 0,1
F
:
7,5 ± 0,1
3000
min 300 mm
min 500 mm
min 300 mm
EMBOSSED CARRIER TAPE
Po
Do
P2
E
Ao
G (m in) :
0,60
P2
:
P1
:
D1(m in) :
2
8
1,5
Ao
:
5,30
Bo
:
9,70
± 0,1
CT
:
13,5
± 0,1
F
D1
± 0,1
± 0,1
W
Bo
CT
G
± 0,1
P1
COVER TAPE
W 2
Reel (all dimensions in mm):
A
:
W1
:
W 2 (max) :
330
16,40 +2,0
22,4
N (min)
:
50
C
:
13,0
+ 0,5/-0.2
A
C
N
W 1
The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape.
Markings on the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on its right.
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs225e.doc
version 1.2
VI TELEFILTER
25.04.2003
Filter specification
TFS 225E
4/5
Air reflow temperature conditions
1st and 2nd air reflow profile
Name:
Temperature:
Time:
pre-heating periods
150 °C - 170 °C
60 sec. - 90 sec.
main-heating periods
over 200 °C
20 sec. - 25 sec.
peak temperature
255 °C ± 5 °C
Chip-mount air reflow profile
260
240
220
200
temperature / °C
180
160
140
120
100
80
60
40
20
0
0
20
40
60
80
100
120
140
160
180
200
220
240
time / sec.
Table for temperature vs. time during the air reflow process
Tolerance of temperatures: ± 5 °C
time / sec.
0
10
20
30
40
50
60
70
80
90
100
110
120
130
temperature / °C
23
34
46
60
80
103
121
134
143
150
154
156
158
159
time / sec.
140
150
160
170
180
190
195
200
205
210
215
220
230
240
temperature / °C
160
161
164
170
180
205
230
255
230
205
180
165
140
120
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs225e.doc
VI TELEFILTER
version 1.2
Filter specification
25.04.2003
TFS 225E
5/5
History
Version
Reason of Changes
Name
Date
1.0
- generate specification
Pfeiffer
13.09.2002
1.1
- terminating impedance added (preliminary values)
- typical values added
Pfeiffer
07.02.2003
1.2
- terminating impedance fixed
Pfeiffer
25.04.2003
TELEFILTER GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.