Data Sheet

UNISONIC TECHNOLOGIES CO., LTD
TL082
LINEAR INTEGRATED CIRCUIT
GENERAL PURPOSE DUAL
J-FET OPERATIONAL
AMPLIFIER

DESCRIPTION
The UTC TL082 is a high speed J-FET input dual operational
amplifier. It incorporates well matched, high voltage J-FET and
bipolar transistors in a monolithic integrated circuit.
The device features high slew rates, low input bias and offset
current, and low offset voltage temperature coefficient.

FEATURES
* Low input bias and offset current
* Wide common-mode (up to VCC+ ) and differential voltage range
* Output short-circuit protection
* High input impedance J-FET input stage
* Internal frequency compensation
* Latch up free operation
* High slewrate:16V/µs(typ.)

ORDERING INFORMATION
Ordering Number
Lead Free
TL082L-D08-T
-
TL082L-D08-T

Halogen Free
TL082G-D08-T
TL082G-S08-R
TL082G-P08-R
Package
Packing
DIP-8
SOP-8
TSSOP-8
Tube
Tape Reel
Tape Reel
(1)Packing Type
(1) R: Tape Reel, T: Tube
(2)Package Type
(2) D08: DIP-8, S08: SOP-8, P08: TSSOP-8
(3)Green Package
(3) L: Lead Free, G: Halogen Free and Lead Free
MARKING
DIP-8
www.unisonic.com.tw
Copyright © 2015 Unisonic Technologies Co., Ltd
SOP-8
TSSOP-8
1 of 7
QW-R105-019.H
TL082
LINEAR INTEGRATED CIRCUIT

PIN CONFIGURATION

BLOCK DIAGRAM
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
2 of 7
QW-R105-019.H
TL082

LINEAR INTEGRATED CIRCUIT
ABSOLUTE MAXIMUM RATING (TA=25°C)
PARAMETER
SYMBOL
RATINGS
UNIT
Supply Voltage (Note 2)
VCC
±18
V
Input Voltage (Note 3)
VIN
±15
V
Differential Input Voltage (Note 4)
VID
±30
V
Power Dissipation
PD
680
mW
Output Short-Circuit Duration (Note 5)
Infinite
Operating Temperature
TOPR
-20 ~ +85
°C
Storage Temperature Range
TSTG
-65 ~ +150
°C
Notes: 1. Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
2. All voltage values, except differential voltage, are with respect to the zero reference level (ground) of the
supply voltages where the zero reference level is the midpoint between VCC- and VCC+.
3. The magnitude of the input voltage must never exceed the magnitude of the supply voltage or 15 volts,
whichever is less.
4. Differential voltages are at the non-inverting input terminal with respect to the inverting input terminal.
5. The output may be shorted to ground or to either supply. Temperature and/or supply voltages must be
limited to ensure that the dissipation rating is not exceeded.

THERMAL DATA
PARAMETER
Junction to Ambient
Junction to Case

SYMBOL
SOP-8
DIP-8
TSSOP-8
SOP-8
DIP-8
TSSOP-8
θJA
θJC
RATINGS
125
85
120
40
41
37
UNIT
°C/W
°C/W
°C/W
°C/W
°C/W
°C/W
ELECTRICAL CHARACTERISTICS
( VCC=±15V, TA=25°C, TMIN=0°C, TMAX=70°C , unless otherwise specified)
PARAMETER
SYMBOL
TEST CONDITIONS
TA=25°C
Input Offset Voltage (RS=50Ω)
VIO
TMIN ≤TA ≤TMAX
Input Offset Voltage Drift
DVIO
TA=25°C
Input Offset Current (Note)
IIO
TMIN ≤TA ≤TMAX
TA=25°C
Input Bias Current (Note)
IIB
TMIN ≤TA ≤TMAX
Input Common Mode Voltage Range
Output Voltage Swing
VICM
±VOPP
Large Signal Voltage Gain
(RL=2kΩ, VOUT=±10V)
Avd
Gain Bandwidth Product (Ta=25°C)
GBP
Input Resistance
Common Mode Rejection Ratio
(RS=50Ω)
Supply Voltage Rejection Ratio
(RS=50Ω)
MIN
10
5
20
±11
TA=25°C, RL=2kΩ,
TA=25°C, RL=10kΩ
TMIN ≤TA ≤TMAX, RL=2kΩ
TMIN ≤TA≤ TMAX, RL=10kΩ
TA=25°C
TMIN ≤TA ≤TMAX
VIN=10mV, RL=2kΩ,
CL=100pF, f=100kHZ
10
12
10
12
25
15
2.5
SVR
-12~+1
5
12
13.5
200
4
12
RI
CMR
TYP
3
TA=25°C
TMIN ≤TA ≤TMAX
TA=25°C
TMIN ≤TA ≤TMAX
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
70
70
70
70
10
86
86
MAX
10
13
100
10
400
20
UNIT
mV
µV/°C
pA
nA
pA
nA
V
V
V
V
V
V/mV
MHz
Ω
dB
dB
3 of 7
QW-R105-019.H
TL082

LINEAR INTEGRATED CIRCUIT
ELECTRICAL CHARACTERISTICS (Cont.)
PARAMETER
Supply Current, No Load
Channel Separation
(Av=100, Ta=25°C)
SYMBOL
TEST CONDITIONS
ICC
TA=25°C
MIN
V01/V02
Output Short-Circuit Current
IOS
Slew Rate (Ta=25°C)
SR
Rise Time (Ta=25°C)
tR
Overshoot (Ta=25°C)
KOV
Total Harmonic Distortion (Ta=25°C)
THD
Phase Margin
Φm
TYP
3.6
MAX
5.6
120
TA=25°C
TMIN ≤TA≤TMAX
VIN=10V, RL=2kΩ
CL=100pF, unity gain
VIN =20mV, RL=2kΩ
CL=100pF, unity gain
VIN=20mV, RL=2kΩ
CL=100pF, unity gain
AV=20dB, f=1kHz, RL=2kΩ,
CL=100pF, VOUT=2Vpp)
UNIT
mA
dB
10
10
40
60
60
mA
mA
8
16
V/µs
0.1
µs
10
%
0.01
%
45
Degree
s
Equivalent Input Noise Voltage
eN
15
(RS=100Ω, f=1KHz)
Note: The Input bias currents are junction leakage currents, which approximately double for every 10C increase in
the junction temperature.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
4 of 7
QW-R105-019.H
TL082
LINEAR INTEGRATED CIRCUIT

PARAMETER MEASUREMENT INFORMATION

TYPICAL APPLICATION CIRCUIT
100 KHz Quadruple Oscillators
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
5 of 7
QW-R105-019.H
TL082
TYPICAL CHARACTERISTICS
Supply Current (mA)

LINEAR INTEGRATED CIRCUIT
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
6 of 7
QW-R105-019.H
TL082
LINEAR INTEGRATED CIRCUIT
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
7 of 7
QW-R105-019.H