Introduction bus ic dc/dc converter motor driver ic ripple counter driver ic I/O ic Sensor interface ic sensor ic ip’s SM5651 Low pressure, const. curr. dip SM5652 Low pressure, const. volt. dip SM5812|52 Amplified pressure sensor ÿ E 910.86 Sun angle sensor E 984.01 Calibr. absol. pressure sensor description ÿ Angle-measurement range 10°-170° This IC with integrated sensor-cells is used to locate the position ÿ Temperature range – 40°C to 125°C and to measure the intensity of the sun or other light sources. ÿ Serial Interface (SPI) This is useful in some applications in the automotive and indus- ÿ 2-dimensional detection of angle of incidence trial environment. A famous example is surely the control of the ÿ Measurement of angle of incidence with air condition depending on the position of the sun. approx. 3° resolutions ÿ 2 photo diodes with different spectral sensivities implemented ÿ Demo-Board available application ÿ Use as sun angle /light sensor ÿ Air conditioning control ÿ Automatic tinting of windscreen/mirrors (glare shield) ÿ Illumination control (driving light/interior) ÿ Blind control (building services engineering) ÿ Autolevel of solar cells package Name Description 1 VDD Analog and digital supply 2 GND Ground 3 CSB SPI-interface: chip select 4 SCK SPI-interface: clock 5 MOSI SPI-interface: input, master out slave in 6 NC Not connected 7 NC Not connected 8 NC Not connected 9 NC Not connected 10 NC Not connected 11 MISO SPI-interface: output, master in slave out 12 RESET Logic reset 13 OUT Analog output for intensity and temperature 14 TEST For production test purpose 15 NC Not connected 16 NC Not connected 17 NC Not connected 18 NC Not connected 19 NC Not connected 20 NC Not connected QFN 4x4 (optical) ÿ Pin ÿ ÿ Position finding of light sources pinning THIS PRODUCT IS UNDER DEVELOPMENT features E910.86 ÿ THIS PRODUCT IS UNDER DEVELOPMENT THIS PRODUCT IS UNDER DEVELOPMENT ÿ Sun angle sensor (Optical vernier) Block diagram Note ELMOS Semiconductor AG (below ELMOS) reserves the right to make changes to the product contained in this publication without notice. ELMOS assumes no responsibility for the use of any circuits described herein, conveys no licence under any patent or other right, and makes no representation that the circuits are free of patent infringement. While the information in this publication has been checked, no responsibility, however, is assumed for inaccuracies. ELMOS does not recommend the use of any of its products in life support applications where the failure or malfunction of the product can reasonably be expected to cause failure of a life-support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such applications. 128 Copyright © 2007 ELMOS Reproduction, in part or whole, without the prior written consent of ELMOS, is prohibited. www.elmos.de | [email protected] elmos product catalog 2007/2008 129