SCP800 800W P a r a l l e l ( N + 1) Wi t h P FC Func t i on series AC input 180~260VAC only Protections:Short circuit/Over load/Over voltage/Over temperature PF> 0.98@ 230VAC Built in remote sense function Built-in remote ON-OFF control Built-in power good signal output Built-in parallel operation function(N+1) Can adjust from 20~100% output voltage by external control 1-5V Forced air cooling by built-in DC fan Model Number Output Volts SCP800-12 SCP800-24 12 Volts(DC) 24 Volts(DC) SINGLE OUTPUT WWW.ASTRODYNETDI.COM Output Amps 66 Amps 33Amps Min Load 0~66Amps 0~33Amps Ripple & Noise Efficiency 120mVpk-pk 240mVpk-pk 84% 88% Safety Model No. 800S-P012 800S-P024 ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 SCP800 800W P a r a l l e l ( N + 1) Wi t h P FC Func t i on INPUT SPECIFICATIONS PHYSICAL SPECIFICATIONS Input Voltage Range 180 ~ 260VAC; 260~370VDC Frequency Range 47-63Hz Inrush Current, max: (cold start) 60Amps/230VAC Input Current 5.0Amps@230VAC Leakage current < 3.5mAmps / 240VAC Min Load See Selection Chart Power Factor (typ.) @ FL > 0.98/230VAC Size Weight OUTPUT SPECIFICATIONS Voltage and Current See Selection Chart Line Regulation ±0.5% Load Regulation ±0.5% Voltage Tolerance (Note 2) ±1.0% Ripple/Noise (Note 1) See Selection Chart Hold Up Time @ FL 12mS Setup, Rise Time @ FL 800mS, 400mS Over Voltage Protection 105~135% follow to output set up point Shutdown o/p voltage, re-power Over Current Protection (Note3) 105~115% rated output power Current limiting, delay shut down o/p, re-power Over Temperature Protection > 100°C / measure by heat sink,near transformer, Shutdown o/p voltage auto-recover after cool down DC Voltage Adjust ±0.3% typ. adjustment by potentiometer 20~100% adjustment by 1~5Volts(DC) external control ENVIRONMENTAL SPECIFICATIONS Oper. Temperature Storage Temperature Relative Humidity Temperature Coefficient MTBF Vibration series 290 x 120 x 68 mm (11.42”x 4.72”x 2.68”) 67.02 oz (1900g) GENERAL SPECIFICATIONS Safety EMI Harmonic Current Efficiency Isolation EMS Power Good Signal Special Function Cooling UL60950-1, TUV EN60950-1 Approved Insulation Resistance ≥100MΩ/500Volts(DC)/25°C/70%RH Compliance to EN55022A (CISPR22A) Compliance to EN61000-3-2,-3 See Selection Chart 3000VAC Input - Output 1500VAC Input - Ground 500VAC Output - Ground Compliance to EN61000-4-2,3,4,5,6,8,11 ENV50204, light Industry Level, Criteria A Open collector of NPN transistor DC Volt. Adjust, remote sensing, remote control, parallel operation By fan, >20% load or >50°C fan on NOTE 1. Ripple & noise are measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 2. Tolerance : includes set up tolerance, line regulation and load regulation. 3. Current limiting 3 times(1.5s,3.0s,5.0s)Then intelligent auto recovery before shut down -20°C to +65°C (See Derate Curve) -20°C to +85°C, 10~95% RH 20~90% RH non cond ±0.04% / °C (0-50°C) 74.9KHrs min,MIL-HDBK-217F(25°C) 10~200Hz, 2G10min./1cycle, period for 60min. each along X, Y, Z axes All specifications are typical at nominal input, full load, and 25°C unless otherwise noted WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 800W P a r a l l e l ( N + 1) Wi t h P FC Func t i on WWW.ASTRODYNETDI.COM SCP800 series ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 800W P a r a l l e l ( N + 1) Wi t h P FC Func t i on WWW.ASTRODYNETDI.COM SCP800 series ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458