VCS573 High Kv, 5x7mm VCSO APPLICATIONS Frequency Translation and Jitter Attenuation SONET/SDH 10 GbE WiMAX Base Stations/Picocells DAC clocking FEATURES • • • • • • • • • High Tuning Gain Transfer, Kv Industry Standard 5x7mm SMT Footprint +3.3 Vdc Supply Voltage -40°C to 85°C Temp. Range LVPECL differential outputs ± 50ppm Absolute Pull Range (APR) Output Enable/Disable Function SAW filter design Extremely Low Jitter DESCRIPTION Surface mount 5x7mm VCSO operating at 3.3V supply with complementary LVPECL outputs for use in datacom, telecom, and DAC clock applications. ELECTRICAL SPECIFICATIONS Parameter Operating Conditions Min Typical Max Unit 600 622.08, 644.5313, 666.514, 669.3266 693.483, 768 1000 MHz Operating Temperature Range -40 - 85 °C Storage Temperature Range -55 - 125 °C Nominal Frequency Conditions & Remarks fNOM Supply Voltage VCC; ±5% 3.135 3.300 3.465 Vdc Supply Current Icc; Max. VCC; TA = 25°C load = 50Ω to VCC – 2V - 65 75 mA Load output to VCC -2V - 50 - Ω ref to TA = 25°C; VC = constant - +20 -160 - ppm Frequency Stability Frequency vs. Temperature Electronic Frequency Control Input Impedance Zi 50 100 - kΩ Control Voltage Range VC ; positive monotonic transfer 0.3 - 3.0 Vdc Gain Transfer Kv - 350 - ppm/V Absolute Pull Range APR; all causes (see Note 1) ± 50 - - ppm Modulation Bandwidth -3dB ref. 100Hz - 50 - kHz Linearity Deviation from best linear fit - ±4 ±10 % NOTE 1: Minimum guaranteed frequency shift (∆f/fNOM) under all conditions (temperature, aging, supply voltage, load) for 15 years at an average effective operating temperature of +55°C ELECTRICAL SPECIFICATIONS (Continued) Document No. VCS573 Data Sheet Page 1 - 5 Rev. X1 ٠ ٠ ٠ CTS Electronic Components, Inc. ٠ 171 Covington Drive ٠ Bloomingdale, IL 60108 ٠ ٠ ٠ ٠ ٠ ٠ www.ctscorp.com ٠ ٠ ٠ VCS573 High Kv, 5x7mm VCSO Parameter Output Parameters Conditions & Remarks Min Output Signal Rise/Fall Times 20% to 80% Duty Cycle @ 50% of output signal Start up time to reach 90% of final amplitude Phase Jitter Unit VOL - - VCC-1.620 VOH VCC-1.025 - - Vdc - 250 400 ps 45 50 55 % - - 10 ms 100Hz - -85 - dBc/Hz 1kHz - -110 - dBc/Hz 10kHz - -140 - dBc/Hz 100kHz - -143 - dBc/Hz 1MHz - -143 - dBc/Hz 12kHz to 20MHz (calculated from 622 MHz Phase Noise) - 0.10 0.25 ps RMS 50kHz to 80MHz (calculated from 622 MHz Phase Noise) - 0.10 0.25 ps RMS Typical for 622.08 MHz LVPECL OUTPUT WAVEFORM Pad 2 Low ”0” Open High ”1” Max LVPECL Amplitude Phase Noise Typical TEST CIRCUIT, LVPECL LOAD OUTPUT ENABLE/DISABLE LOGIC Pad 4 outputs disabled PECL Low outputs enabled Output outputs enabled Output Document No. VCS573 Data Sheet Page 2 - 5 Pad 5 PECL High Comp. Output Comp. Output Rev. X1 ٠ ٠ ٠ CTS Electronic Components, Inc. ٠ 171 Covington Drive ٠ Bloomingdale, IL 60108 ٠ ٠ ٠ ٠ ٠ ٠ www.ctscorp.com ٠ ٠ ٠ VCS573 High Kv, 5x7mm VCSO MECHANICAL SPECIFICATIONS PACKAGE DRAWING PIN 6 PIN 5 PIN 4 VCS573 622M0800 PIN #1 MARK PIN 1 PIN 2 PIN 3 2.68 [.105] EXPOSED GROUND PLANE AND COVER CASTELLATION 2 PLACES MAX 0.56 TYP [.022] PIN 1 PIN 2 PIN 3 1.27 [.050] TYP 1.47 [.058] 1.90 [.075] 1.68 [.066] 1.68 [.066] 1.47 [.058] 5.18±0.10 [.204±.004] 1.27 TYP [.050] PIN 6 PIN 5 2.54 [.100] 5.08 [.200] PIN 4 BARRIER COVERING OVER RESIST MASK OVER GROUND PLANE 7.52±0.10 [.296±.004] Lead Termination Finish: Gold flash, <10 micro inch, over 100 micro inch minimum Ni plated Cu Co-Planarity (from seating plane): 0.1 [0.004] maximum Dimensions in mm and [inches] PAD FUNCTION 1 - Control Voltage - VC 2 - Enable/Disable Control 3 - Ground/Case 4 - Output 5 - Complementary Output 6 - Supply Voltage - VCC Document No. VCS573 Data Sheet Page 3 - 5 Rev. X1 ٠ ٠ ٠ CTS Electronic Components, Inc. ٠ 171 Covington Drive ٠ Bloomingdale, IL 60108 ٠ ٠ ٠ ٠ ٠ ٠ www.ctscorp.com ٠ ٠ ٠ VCS573 High Kv, 5x7mm VCSO SUGGESTED SOLDER PAD GEOMETRY 5.08 [.200] 2.54 [.100] 1.70 [.067] 3.83 [.151] 5.54 [.218] 2.34 [.092] 1.68 [.066] Dimensions are in mm and [inches]. MAXIMUM SOLDERING PROFILE Temperature 217°C 260°C (Absolute max temperature) Time 60-150 sec 10 sec. max Note: Part is not designed to be reflowed in an inverted position. TAPE AND REEL INFORMATION 17.5 2.0 Ø13 Ø1.50 1.75 VCSXXXX CTS YYWW VCSXXXX CTS YYWW 7.80 7.60 3.10 2.90 4.00 8.00 5.60 5.40 120° 7.50 Ø60 16.00 DIMENSIONS ARE IN MM Ø23 DIRECTION OF FEED Device quantity is 1000 pieces max. per 180mm reel. Document No. VCS573 Data Sheet Page 4 - 5 Rev. X1 ٠ ٠ ٠ CTS Electronic Components, Inc. ٠ 171 Covington Drive ٠ Bloomingdale, IL 60108 ٠ ٠ ٠ ٠ ٠ ٠ www.ctscorp.com ٠ ٠ ٠ Ø180 VCS573 High Kv, 5x7mm VCSO ENVIRONMENTAL SPECIFICATIONS This product is capable of operating within the following environmental conditions: Operating Temperature Storage Temperature Humidity Atmospheric Pressure Moisture Sensitivity RoHS -40 to +85 °C -55 to 125°C 95% Relative humidity max @ 40°C 730 to 780 mm Hg Level 1 Fully compliant to RoHS Directive 2002/95/EC Model 3571 Part Number Generator: Frequency in MHz (“M” = decimal point) VCS573 - _ _ _M_ _ _ _ P/N example: VCS573-622M0800 Document No. VCS573 Data Sheet Page 5 - 5 Rev. X1 ٠ ٠ ٠ CTS Electronic Components, Inc. ٠ 171 Covington Drive ٠ Bloomingdale, IL 60108 ٠ ٠ ٠ ٠ ٠ ٠ www.ctscorp.com ٠ ٠ ٠