ADATA SX300/SP300 mSATA SSD User’s Manual Intel Smart Response Technology Setup Guide Step 1. Boot into BIOS Setup Menu Notes: For GIGABYTE motherboard press delete key to enter BIOS www.adata-group.com ADATA SX300/SP300 mSATA SSD User’s Manual Step 2. Set ‘PCH SATA control mode’ to RAID (XHD) Step 3. Install OS (Windows 7, Vista or later) and other required devices drivers including Intel Rapid Storage Utility 1. www.adata-group.com ADATA SX300/SP300 mSATA SSD User’s Manual 2. 3. www.adata-group.com ADATA SX300/SP300 mSATA SSD User’s Manual 4. Step 3a. Intel Rapid Storage Utility 1. www.adata-group.com ADATA SX300/SP300 mSATA SSD User’s Manual 2. 3. www.adata-group.com ADATA SX300/SP300 mSATA SSD User’s Manual Step 4. Turn off your computer Step 5. Insert ADATA SX300/SP300 SSD on the mSATA slot for Ultrabook for Desktop www.adata-group.com ADATA SX300/SP300 mSATA SSD User’s Manual Step 6. Boot into OS Step 7. Run the ISRT software through the task bar icon Step 8. Click “Enable acceleration” under “Accelerate” www.adata-group.com ADATA SX300/SP300 mSATA SSD User’s Manual Step 9. Select the acceleration mode, and then click “OK. By default, Enhanced mode is selected Note: Enhanced mode: Acceleration optimized for data protection. Maximized mode (recommend) : Acceleration optimized for input/output performance. Step 10. The page refreshes and reports the new acceleration configuration in the Acceleration View www.adata-group.com ADATA SX300/SP300 mSATA SSD User’s Manual Step 11. Congratulations! Yours system is now successfully configured with Intel Smart Response Technology! All brand names of Intel® are registered trademarks of Intel® Corporation. Registered trademarks ® 2011 by Intel Corporation reserved. www.adata-group.com