NEW 5.8mm Round ® OptopipeTM Optical Light Pipe, Single 11.68 [.460] 5.84 [.230] MicroLED SMT LEDs for use with 515-1039 22.35 [.880] Ø 5.85 [.230] CURVED & DIFFUSED FRONT SURFACE 22.40 [.882] 25.40 [1.00] 2.54 [.100] 5.30 [.210] 4.39 [.173] .41 [.016] TYP 1.09 [.043] TYP PART NO. FRONT PANEL Ø 2.94 [.116] MOUNTING PINS (2) PLACES 8.79 [.346] .76 [.030] 515-1039 17.86 [.703] 25.4 [1.00] 1.50 [.059] TYP 8.79±.08 [.346±.003] 1.50 [.059] TYP 7.62 [.300] NOTE: designed for post-reflow PC board insertion. DIRECTION OF LIGHT [Ø .113 ±.002] TYP; 2 PLCS 3.81 [.150] Dimensions in mm [inches] RECOMMENDED SOLDER PAD/HOLES LAYOUT Features • • • • • Recommended 597-3xx1-2xx 597-3211-2xx 597-77x1-2xx Alternatives 597-3xxx-4xx 597-3xx1-1xx 597-3xx1-4xx 597-3xx1-5xx 597-77x1-1xx 597-77x1-5xx PAGE # 1-21 1-21 1-23 1-27 1-19 1-28 1-30 1-20 1-31 LED alternatives may not produce optimum light output Solder Pad/Holes layout shown is for bi-color LEDs listed under “Recommended” category Contact factory for other layouts High transmissivity polycarbonate material UL94V-0 compliance ESD protection (circuit isolation from front panel) Wide viewing angle Secures to PCB by press-fit LED Data For absolute maximum ratings and other electrical and optical data on the recommended LEDs, refer to LED data sheets. Operating/Storage Temperature –30°C to +100°C Dialight Optopipe Light Pipe Description This Optopipe™ is a taller version of 515-1038. The SMT LEDs are mounted in a straight line under the rear of the part. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index. Dialight can provide custom Optopipe™ solutions for your applications. 2-48 Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: (732) 919-3119 • FAX: (732) 751-5778 •www.dialight.com