Thomas Research Products SSL Solutions Faster Than The Speed Of Light ® LED-100W Series– Fixed Output and Dimmable Switch Mode LED Drivers Constant Current & Constant Voltage with Isolation Black Magic Thermal Advantage™ Aluminum Housing Total Power: 100 Watts Input Voltage: 100-277 Vac Outputs: Single from 6 - 286 Vdc Indoor or Outdoor Applications High Power Factor UL8750, EN61347, CSA 22.2 EN61000-3-2, EN61000-3-3 Class C Electrical Specifications Input Voltage Range: 100-277 Vac Nom. (90-305 V Min/Max) Frequency: 50/60 Hz Nom. (47-63 Hz Min/Max) Power Factor: >0.90 @ full load, 100V through 277V Inrush Current: <30.0 Amps max @ 230 Vac, cold start 25ºC Input Current: 1.30 Amps max Maximum Power: 100W Current Accuracy: ± 1% Over input line variation Load Regulation: ± 3% THD: < _ 20% @ full load Leakage Current: 400 µA Typical Hold Up Time: Half Cycle Protection: utput Over-Voltage, Output Over-Current, and O Output Short Circuit Protection reset by power cycling Electrical Specifications Constant Current - Product Specifications Model Number Output Current Output Voltage (mA ±3%) Range (Vdc) Max. Output Power (W) Typical Efficiency LED100W-286-C0350-XX 350 95-286 100 92% LED100W-222-C0450-XX 450 74-222 100 92% LED100W-143-C0700-XX 700 47-143 100 91% LED100W-095-C1050-XX 1050 31-95 100 91% 91% Operating Temperature: -30ºC to +65ºC Maximum Case Temp. 90°C Storage Temperature: -40ºC to +85ºC LED100W-071-C1400-XX 1400 23-71 100 Humidity: 5% to 95% LED100W-057-C1750-XX 1750 19-57 100 90% Cooling: Convection LED100W-048-C2100-XX 2100 16-48 100 90% Vibration Frequency: 5 to 55 Hz/2g, 30 minutes LED100W-041-C2450-XX 2450 13-41 100 90% MTBF: 18,000 Hours at full load and 40ºC ambient conditions 4 per MIL-217F Notice 2 LED100W-036-C2800-XX 2800 12-36 100 90% LED100W-032-C3150-XX 3150 10-32 100 90% LED100W-028-C3570-XX 3570 9-28 100 89% EMC: FCC 47CFR Part 15 Class B compliant LED100W-024-C4200-XX 4200 8-24 100 89% LED100W-020-C5000-XX 5000 7-20 100 88% LED100W-018-C5550-XX 5550 6-18 100 88% -XX indicates dimming options are available. See options at left. Blank = fixed current output Ordering Options: -D: 0-10V & Resistance dimmable version comes with an extra two wires +Purple/-Gray on the output side. -D 0-10V Dimming is compatible with most quality 0-10V wall dimmers. See page 3 for additional specifications. -PD: PWM Dimmable version comes with an extra two wires +Purple/-Gray on the output side. PD PWM version is PWM Dimmable via a positive 10% to 100% Duty Cycle, 200Hz to 1KHz, 0-10V Pulse. See page 4 for additional specifications. E332160 Note: LED drivers are designed and intended to operate LED loads only. Non-LED loading may be outside the specified design limits of our LED driver, and therefore cannot covered by any warranty. If you desire to use our LED drivers to operate non-LED loads please contact us to discuss compatibility. Constant Voltage - Product Specifications Model Number Output Voltage Output Current (Vdc ±5%) Range (mA) Max. Output Power (W) Typical Efficiency LED100W-286 286 88-350 100 92% LED100W-222 222 113-450 100 92% LED100W-143 143 175-700 100 91% LED100W-095 95 263-1050 100 91% LED100W-071 71 350-1400 100 91% LED100W-057 57 438-1750 100 90% LED100W-048 48 525-2100 100 90% LED100W-041 41 613-2450 100 90% LED100W-036 36 700-2800 100 90% LED100W-032 32 788-3150 100 90% LED100W-028 28 893-3570 100 89% LED100W-024 24 1050-4200 100 89% LED100W-020 20 1250-5000 100 88% LED100W-018 18 1388-5550 100 88% Specifications subject to change without notice. Thomas Research Products • 11548 Smith Dr. • Huntley, IL 60142 • T: 847-515-3057 • F: 847-515-3047 • www.trpssl.com 7-11-13 Thomas Research Products SSL Solutions Faster Than The Speed Of Light ® LED100W Pg 2 of 4 Dimensions - Inches (mm) WIRE SPECS: AC Input: UL2733 Jacketed #18AWG DC Output: UL2733 Jacketed #18AWG Dimming Control: UL2733 Jacketed #22AWG Dimming Purple (+) Gray (-) INPUT Black (L) White (N) Green (GND) OUTPUT Red (+) Black (-) Tc = Case Hot Spot Power Factor / Load 1.00 0.90 45% 0.80 40% 0.70 35% 0.60 30% THD PF THD / Load 50% 0.50 0.40 25% 120Vac 277Vac 0.30 0.20 15% 0.10 10% 0.00 50% 60% 70% 80% 90% Load 120Vac 277Vac 20% 100% 0% 50% 60% 70% 80% Load 90% 100% Lifetime/Case Temperature (Full Load @ 120Vac) 350 Lifetime (kHrs) 300 250 200 150 100 50 0 45 50 55 60 65 70 75 80 85 Case Hotspot Temperature (°C) 90 UL Conditions of Acceptability See website for additional information Thomas Research Products • 11548 Smith Dr. • Huntley, IL 60142 • T: 847-515-3057 • F: 847-515-3047 • www.trpssl.com Thomas Research Products SSL Solutions Faster Than The Speed Of Light ® LED100W Pg 3 of 4 “-D” Option: 0-10VDC and Resistance Dimming Parameters Minimum Typical Maximum 0 mA -2.0 V — — 10 mA +15 V Source Current out of 0-10V Purple Wire Absolute Voltage Range on 0-10V (+) Purple Wire Typical Dimming Circuit Dim (+) Purple LED100W-XX-CXXXX-D IP710 Wall Dimmer Dim (-) Gray (Dimmer must be current-sink type control) Output Current / 0-10VDC Dimming Input Output Current % 100 90 80 70 60 50 40 30 20 10 0 0V 1V 2V 3V 4V 5V 6V Dimming Input (Vdc) 7V 8V 9V 10V Notes: 1. 0-10V dimmable version comes with an extra two wires +Purple/-Gray on the output side. 2. Compatible with most 0-10V Wall Slide dimmers and direct 0-10V analog signal. Recommended dimmer is Leviton IP710 or equivalent 3. 0-10V dimmable version is not intended to dim below about 5% @ 0V or 10% @ 1.0V 4. 0-10V dimmable version output will be 100% with Purple/Gray open and minimum with Purple/Gray Shorted. Thomas Research Products • 11548 Smith Dr. • Huntley, IL 60142 • T: 847-515-3057 • F: 847-515-3047 • www.trpssl.com Thomas Research Products SSL Solutions Faster Than The Speed Of Light ® LED100W Pg 4 of 4 “-PD” Option: PWM Dimming Parameters Absolute Maximum Voltage Range on PWM Input (Purple Wire) Input LOW Level Voltage Range (Purple Wire) Input HIGH Level Voltage Range (Purple Wire) Sink Current into PWM Input (Purple Wire) PWM Input Signal Frequency PWM Input Signal Positive Duty Cycle Minimum Typical Maximum -2.0V -2.0 +9.0 0mA 200Hz 0% 10V 0V 10V — — 10-90% +28V +7.5V 28V 1.2mA 1000Hz 100% PWM Positive Dimming Typical Circuit PWM (+) Purple LED100W-XX-CXXXX-PD PWM In PWM (-) Gray Output Current / Positive Duty Cycle Output Current % 100 90 80 70 60 50 40 30 20 10 0 0% 10% 20% 30% 40% 50% 60% Positive Duty Cycle 70% 80% 90% 100% Notes: 1. PWM Dimmable version comes with an extra 2 wires +Purple/-Gray on the output side. 2. Below 10% Duty cycle proper dimming operation is not assured. Unit is not intended to turn off at <10% Duty Cycle. 3. PWM dimmable version output will be 100% with Purple/Gray open and minimum with Purple/Gray Shorted. Thomas Research Products • 11548 Smith Dr. • Huntley, IL 60142 • T: 847-515-3057 • F: 847-515-3047 • www.trpssl.com