Thomas Research Products

Thomas Research Products
SSL Solutions Faster Than The Speed Of Light ®
PLED-96W Series– Fixed Output & Dimmable
Total Power: 96 Watts
Input Voltage: 100-277 Vac Nom.
Outputs: Single from 6-274 Vdc
Dry-Damp-Wet Location Rated,
IP66, NEMA6
High Power Factor
Compact, Switch Mode LED Drivers
Constant Current & Constant Voltage with Isolation
Black Magic Thermal Advantage™ Aluminum Housing
Electrical Specifications
Input Voltage Range:
100-277 Vac Nom. (90-305 V Min/Max)
Frequency:
50/60 Hz Nom. (47-63 Hz Min/Max)
Power Factor:
>0.90 @ full load, 100V through 277V
Inrush Current:
<30.0 Amps max @ 230 Vac, cold start 25ºC
Input Current:
1.30 Amps max
Maximum Power:
96W
Current Accuracy:
± 1% Over input line variation
Load Regulation:
± 3%
THD:
<
_ 20% @ full load
Leakage Current:
400 µA Typical
Hold Up Time:
Half Cycle
Output Protection:
Over-Voltage, Over-Current, and
Short Circuit Protection with Auto Recovery
Environmental Specifications
Constant Current Versions - Specifications
Model Number
Output Current Output Voltage Max. Output
Max
Power (W) Efficiency
(mA ±5%)
Range (Vdc)
PLED96W-274-C0350-XX
350
92-274
96
92%
PLED96W-213-C0450-XX
450
71-213
96
92%
PLED96W-137-C0700-XX
700
46-137
96
92%
PLED96W-092-C1050-XX
1050
31-92
96
91%
PLED96W-069-C1400-XX
1400
23-69
96
91%
PLED96W-054-C1750-XX
1750
18-54
94.5
91%
Operating Temperature:
-30ºC to +65ºC
PLED96W-048-C2000-XX
2000
16-48
96
90%
Maximum Case Temp.
90°C
PLED96W-046-C2100-XX
2100
16-46
96
90%
Storage Temperature:
-40ºC to +85ºC
Humidity:
5% to 95%
Cooling:
Convection
Vibration Frequency:
Impact Resistance:
MTBF:
PLED96W-039-C2450-XX
2450
14-39
96
89%
PLED96W-036-C2660-XX
2660
12-36
96
89%
PLED96W-034-C2800-XX
2800
12-34
96
89%
5 to 55 Hz/2g, 30 minutes
PLED96W-030-C3150-XX
3150
10-30
96
89%
PLED96W-027-C3500-XX
3500
9-27
96
88%
1g/s
PLED96W-025-C3840-XX
3840
9-25
96
88%
74,000 Hours @ full load and 40ºC ambient conditions
4
per MIL-217F Notice 2
PLED96W-024-C4000-XX
4000
8-24
96
88%
PLED96W-020-C4800-XX
4800
7-20
96
87%
EMC:
FCC 47CFR Part 15 Class B compliant
PLED96W-018-C5350-XX
5350
6-18
96
86%
Weight:
21.6 oz. (612 grams)
-XX indicates dimming options are available. See options at left. Blank = fixed current output
Ordering Options:
Constant Voltage Versions - Specifications
Output Voltage Output Current Max. Output
Max
Power (W) Efficiency
(Vdc ±5%)
Range (mA)
-D:0-10V & Resistance dimmable version comes with an extra two wires +Purple/-Gray on
the output side. 0-10V Dimming is compatible with most quality 0-10V wall dimmers.
See page 3 for additional specifications.
Model Number
PLED96W-274
274
88-350
96
92%
-D3:3-wire dimmable model comes with three extra wires Yellow/Purple/Gray on the output
side. 3-wire dimming is compatible with potentiometer dimming.
PLED96W-213
213
113-450
96
92%
PLED96W-137
137
175-700
96
92%
-PD: PWM Dimmable version comes with an extra two wires +Purple/-Gray on the output side.
PD PWM version is PWM Dimmable via a positive 10% to 100% Duty Cycle, 200Hz to
1KHz, 0-10V Pulse. See page 4 for additional specifications.
PLED96W-092
92
263-1050
96
91%
PLED96W-069
69
350-1400
96
91%
PLED96W-054
54
438-1750
96
91%
PLED96W-048
48
500-2000
96
90%
PLED96W-046
46
525-2100
96
90%
PLED96W-039
39
613-2450
96
89%
PLED96W-036
36
665-2660
96
89%
PLED96W-034
34
700-2800
96
89%
PLED96W-030
30
788-3150
96
89%
PLED96W-027
27
875-3500
96
88%
PLED96W-025
25
960-3840
96
88%
PLED96W-024
24
1000-4000
96
88%
PLED96W-020
20
1200-4800
96
87%
PLED96W-018
18
1338-5350
96
86%
E332160
Note:
LED drivers are designed and intended to operate LED loads only.
Non-LED loading may be outside the specified design limits of our
LED driver, and therefore cannot covered by any warranty. If you
desire to use our LED drivers to operate non-LED loads please
contact us to discuss compatibility.
Specifications subject to change without notice.
Class 2:
US/Canada
US Only
Thomas Research Products • 11548 Smith Dr. • Huntley, IL 60142 • T: 847-515-3057 • F: 847-515-3047 • www.trpssl.com
7-29-13
Thomas Research Products
SSL Solutions Faster Than The Speed Of Light ®
PLED-96W
Pg 2 of 4
Dimensions - mm
WIRE SPECS:
AC Input: UL2733 Jacketed #18AWG
DC Output: UL2733 Jacketed #18AWG
Dimming Control: UL2733 Jacketed #22AWG
Dimming
Purple (Dim+)
Gray (Dim-)
INPUT
Black (ACL)
White (ACN)
Green (GND)
OUPUT
Red (V+)
Blue (V-)
Lifetime / Case Temperature
(Full Load @ 120Vac)
225
Lifetime (kHrs)
200
175
150
125
100
75
50
25
0
45
50
55
60
65
70
75
80
85
Case Hotspot Temperature (°C)
90
Safety and EMC Compliance
UL8750
CSA-C22.2
EN61347
EN61000-3-2
EN61000-3-3 Class C
FCC 47CFR Part 15 Class B compliant
UL Conditions of Acceptability
See website for additional information
Thomas Research Products • 11548 Smith Dr. • Huntley, IL 60142 • T: 847-515-3057 • F: 847-515-3047 • www.trpssl.com
Thomas Research Products
SSL Solutions Faster Than The Speed Of Light ®
PLED-96W
Pg 3 of 4
"-D" and "-D3" Options: 0-10VDC and Resistance Dimming
Parameters
Minimum
Typical
Maximum
0mA
-2.0V
—
—
2mA
+15V
Source Current out of 0-10V Purple Wire
Absolute Voltage Range on 0-10V (+) Purple Wire
Typical Dimming Circuit
3-Wire Dimming Typical Circuit
10V Output (Yellow)
Dim (+) Purple
PLED96W-xxx-Cxxxx-D
PLED96W-xxx-Cxxxx-D3
IP710 Wall Dimmer
0-10V Input (Purple)
20K
Potentiometer
Return (Gray)
Dim (-) Gray
(Dimmer must be current-sink type control)
Output Current / 0-10VDC Dimming Input
Output Current %
100
90
80
70
60
50
40
30
20
10
0
0V
1V
2V
3V
4V
5V
6V
Dimming Input (Vdc)
7V
8V
9V
10V
Notes:
1. 0-10V dimmable version comes with an extra two wires +Purple/-Gray on the output side.
2. Compatible with most 0-10V Wall Slide dimmers and direct 0-10V analog signal. Recommended dimmer is Leviton IP710 or equivalent
3. 0-10V dimmable version is not intended to dim below about 5% @ 0V or 10% @ 1.0V
4. 0-10V dimmable version output will be 100% with Purple/Gray open and minimum with Purple/Gray Shorted.
5. 3-wire dimmable drivers come with three wires on the output side (Yellow/Purple/Gray).
Thomas Research Products • 11548 Smith Dr. • Huntley, IL 60142 • T: 847-515-3057 • F: 847-515-3047 • www.trpssl.com
Thomas Research Products
SSL Solutions Faster Than The Speed Of Light ®
PLED-96W
Pg 4 of 4
"-PD" Option: PWM Dimming
Parameters
Absolute Maximum Voltage Range on PWM Input (Purple Wire)
Input LOW Level Voltage Range (Purple Wire)
Input HIGH Level Voltage Range (Purple Wire)
Sink Current into PWM Input (Purple Wire)
PWM Input Signal Frequency
PWM Input Signal Positive Duty Cycle
Minimum
Typical
Maximum
-2.0V
-2.0
+9.0
0mA
200Hz
0%
10V
0V
10V
—
—
10-90%
+28V
+7.5V
28V
1.2mA
1000Hz
100%
PWM Positive Dimming Typical Circuit
PWM (+) Purple
PLED96W-xxx-Cxxxx-PD
PWM In
PWM (-) Gray
Output Current / Positive Duty Cycle
Output Current %
100
90
80
70
60
50
40
30
20
10
0
0%
10%
20%
30%
40%
50%
60%
Positive Duty Cycle
70%
80%
90%
100%
Notes:
1. PWM Dimmable version comes with an extra 2 wires +Purple/-Gray on the output side.
2. Below 10% Duty cycle proper dimming operation is not assured. Unit is not intended to turn off at <10% Duty Cycle.
3. PWM dimmable version output will be 100% with Purple/Gray open and minimum with Purple/Gray Shorted.
Thomas Research Products • 11548 Smith Dr. • Huntley, IL 60142 • T: 847-515-3057 • F: 847-515-3047 • www.trpssl.com