PM50RL1C060 Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697 (724) 925-7272 www.pwrx.com Intellimod™ L1-Series Three Phase IGBT Inverter + Brake 50 Amperes/600 Volts A D F E 1 5 N G G G G G G G G G G G G G G F F F 9 M P 13 J B H (2 TYP.) C K B P N L U L L F V Q W R L L V U (19 TYP.) TERMINAL CODE S C T Y 1 VUPC Z 2 UFO 3 UP W X 4 VUP1 5 VVPC WFO VWPC Br FO VNC WN VN1 VUPC WP VWP1 VP VVP1 UN VN VVPC VFO UFO UP VUP1 6 VFO 7 VP 8 VVP1 9 VWPC 1.5k 1.5k 1.5k 1.5k 10 WFO VCC IN FO SI OUT VCC OT GND GND IN FO SI OUT VCC OT GND GND IN FO SI OUT OT GND GND IN FO VCC SI OUT OT GND GND IN FO VCC SI OUT OT GND GND IN FO VCC SI OUT VCC OT GND GND IN FO SI OUT GND GND 11 WP OT 12 VWP1 13 VNC 14 VN1 15 Br 16 UN 17 VN 18 WN 19 FO B N W V U P Outline Drawing and Circuit Diagram Dim. Inches Millimeters Dim. Inches Millimeters A B C D E F G H J K L M 3.54 1.97 0.98 3.5 0.2 0.4 0.08 0.17 Dia. 0.8 0.9 0.5 0.012 90.0 50.0 25.0 80.0 5.0 10.0 2.0 4.3 Dia. 20.5 23.0 12.0 0.3 N P Q R S T U V W X Y Z 0.58 0.26 0.02 0.56 0.1±0.02 0.31 0.02 Sq. 0.08 0.69±0.02 2.20 0.52 0.65 14.6 6.7 0.5 14.2 2.5±0.5 8.0 0.5 Sq. 2.0 17.5±0.5 55.0 13.0 16.5 03/10 Rev. 1 Description: Powerex Intellimod™ Intelligent Power Modules are isolated base modules designed for power switching applications operating at frequencies to 20kHz. Built-in control circuits provide optimum gate drive and protection for the IGBT and free-wheel diode power devices. Features: £ Complete Output Power Circuit £ Gate Drive Circuit £ Protection Logic –Short Circuit –Over Temperature Using On-chip Temperature Sensing –Under Voltage £ Low Loss Using Full Gate CSTBT™ IGBT Chip Applications: £ Inverters £ UPS £ Motion/Servo Control £ Power Supplies Ordering Information: Example: Select the complete part number from the table below -i.e. PM50RL1C060 is a 600V, 50 Ampere Intellimod™ Intelligent Power Module. Type Current Rating Amperes VCES Volts (x 10) PM 50 60 1 Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697 (724) 925-7272 www.pwrx.com PM50RL1C060 Intellimod™ L1-Series Three Phase IGBT Inverter + Brake 50 Amperes/600 Volts Absolute Maximum Ratings, Tj = 25°C unless otherwise specified Characteristics Symbol Power Device Junction Temperature Storage Temperature PM50RL1C060 Units Tj -20 to 150 °C Tstg -40 to 125 °C Mounting Torque, M4 Mounting Screws — 15 in-lb Module Weight (Typical) — 150 Grams Supply Voltage, Surge (Applied between P - N) VCC(surge) 500 Volts Self-protection Supply Voltage Limit (Short Circuit protection Capability)* VCC(prot.) 400 Volts VISO 2500 Volts VCES 600 Volts Isolation Voltage, AC 1 minute, 60Hz Sinusoidal IGBT Inverter Sector Collector-Emitter Voltage (VD = 15V, VCIN = 15V) Collector Current (TC = 25°C) (Note 1) ±IC 50 Amperes ±ICP 100 Amperes PC 168 Watts VCES 600 Volts Peak Collector Current (TC = 25°C) Collector Dissipation (TC = 25°C) (Note 1) IGBT Brake Sector Collector-Emitter Voltage (VD = 15V, VCIN = 15V) Collector Current (TC = 25°C) (Note 1) ±IC 50 Amperes ±ICP 100 Amperes Collector Dissipation (TC = 25°C) (Note 1) PC 168 Watts Diode Forward Current (TC = 25°C) IF 50 Amperes VR(DC) 600 Volts VD 20 Volts Peak Collector Current (TC = 25°C) Diode Rated DC Reverse Voltage (TC = 25°C) Control Sector Supply Voltage (Applied between VUP1-VUPC, VVP1-VVPC, VWP1-VWPC, VN1-VNC) Input Voltage (Applied between UP-VUPC, VP-VVPC, WP-VWPC, UN- VN- WN-Br-VNC) VCIN 20 Volts Fault Output Supply Voltage VFO 20 Volts IFO 20 mA (Applied between UFO-VUPC, VFO-VVPC, WFO-VWPC, FO-VNC) Fault Output Current (UFO, VFO, WFO, FO Terminals) *VD = 13.5 ~ 16.5V, Inverter Part, Tj = 125°C Note 1:TC (under the chip) Measurement Point BOTTOM VIEW Y (0,0) Arm Axis 2 UP X VP WP UN VN WN Br IGBT FWDi IGBT FWDi IGBT FWDi IGBT FWDi IGBT FWDi IGBT FWDi IGBT FWDi X 49.0 49.0 35.0 35.0 21.0 21.0 42.0 42.0 28.0 28.0 14.0 14.0 64.0 68.2 Y 2.8 -3.3 2.8 -3.3 2.8 -3.3 -7.3 -1.2 -7.3 -1.2 -5.3 0.8 3.9 -4.6 03/10 Rev. 1 Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697 (724) 925-7272 www.pwrx.com PM50RL1C060 Intellimod™ L1-Series Three Phase IGBT Inverter + Brake 50 Amperes/600 Volts Electrical and Mechanical Characteristics, Tj = 25°C unless otherwise specified Characteristics Symbol Test Conditions Min. Typ. Max. Units VCE(sat) VD = 15V, VCIN = 0V, IC = 50A, — 1.65 — Volts — 1.65 — Volts — 1.7 — Volts — 1.0 — µs IGBT Inverter Sector Collector-Emitter Saturation Voltage Tj = 25°C VD = 15V, VCIN = 0V, IC = 50A, Tj = 125°C Diode Forward Voltage Inductive Load Switching Times VEC -IC = 50A, VCIN = 15V, VD = 15V ton trr VD = 15V, VCIN = 0 ⇔ 15V — 0.2 — µs tC(on) VCC = 300V, IC = 50A — 0.4 — µs toff Tj = 125°C tC(off) Collector-Emitter Cutoff Current ICES — 1.0 — µs — 0.3 — µs VCE = VCES, VD = 15V, Tj = 25°C — — 1.0 mA VCE = VCES, VD = 15V, Tj = 125°C — — 10 mA VD = 15V, VCIN = 0V, IC = 50A, — 1.65 — Volts — 1.65 — Volts IGBT Brake Sector Collector-Emitter Saturation Voltage VCE(sat) Tj = 25°C VD = 15V, VCIN = 0V, IC = 50A, Tj = 125°C Forward Voltage VFM IF = 50A — 1.7 — Volts Collector-Emitter Cutoff Current ICES VCE = VCES, VD = 15V, Tj = 25°C — — 1.0 mA VCE = VCES, VD = 15V, Tj = 125°C — — 10 mA VD = 15V, VCIN = 15V, VN1-VNC — 20 30 mA Control Sector Circuit Current ID Input ON Threshold Voltage Vth(on) Input OFF Threshold Voltage Vth(off) Short Circuit Trip Level SC Over Temperature Protection (Detect Tj of IGBT Chip) Supply Circuit Under-voltage Protection (-20 ≤ Tj ≤ 125°C) Fault Output Current* Minimum Fault Output Pulse Width* — 5 10 mA Applied between UP-VUPC, 1.2 1.5 1.8 Volts VP-VVPC, WP-VWPC, UN- VN- WN-Br-VNC 1.7 2.0 2.3 Volts — — Amperes Inverter Part 100 Brake Part 100 — — Amperes VD = 15V — 0.2 — µs OT Trip Level 135 145 — °C OTR Reset Level — 125 — °C (-20°C ≤ Tj ≤ 125°C, VD = 15V) Short Circuit Current Delay Time VD = 15V, VCIN = 15V, V*P1-V*PC toff(SC) UV Trip Level 11.5 12.0 12.5 Volts UVR Reset Level 12.0 12.5 13.0 Volts IFO(H) VD = 15V, VCIN = 15V — — 0.01 mA IFO(L) VD = 15V, VCIN = 15V — 10 15 mA tFO VD = 15V 1.0 1.8 — ms *Fault output is given only when the internal SC, OT and UV protections schemes of either upper or lower arm device operates to protect it. 03/10 Rev. 1 3 Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697 (724) 925-7272 www.pwrx.com PM50RL1C060 Intellimod™ L1-Series Three Phase IGBT Inverter + Brake 50 Amperes/600 Volts Electrical and Mechanical Characteristics, Tj = 25°C unless otherwise specified Characteristics Symbol Test Conditions Min. Typ. Max. Units Thermal Characteristics, Tj = 25°C unless otherwise specified Characteristic Symbol Condition Min. Typ. Max. Units Junction to Case Thermal Resistance Rth(j-c)Q IGBT (Per 1 Element) (Note 1) — — 0.74* °C/Watt Inverter Part Rth(j-c)D FWDi (Per 1 Element) (Note 1) — — 1.28* °C/Watt Junction to Case Thermal Resistance Rth(j-c)Q IGBT (Note 1) — — 0.74* °C/Watt Brake Part Rth(j-c)D FWDi (Note 1) — — 1.28* °C/Watt Rth(c-f) Case to Fin Per Module, — — 0.085 °C/Watt Contact Thermal Resistance Thermal Grease Applied (Note 1) Recommended Conditions for Use Characteristic Symbol Condition Value Units Supply Voltage VCC Applied across P-N Terminals ≤400 Volts Control Supply Voltage** VD Applied between VUP1-VUPC, 15.0 ±1.5 Volts VVP1-VVPC, VWP1-VWPC, VN1-VNC Input ON Voltage VCIN(on) Applied between UP-VUPC, ≤0.8 Volts Input OFF Voltage VCIN(off) VP-VVPC, WP-VWPC, UN- VN- WN-Br-VNC ≥9.0 Volts PWM Input Frequency fPWM — ≤20 kHz Arm Shoot-through Blocking Time tDEAD Input Signal ≥2.0 µs * If you use this value, Rth(f-a) should be measured just under the chips. ** With ripple satisfying the following conditions: dv/dt swing ≤ ±5V/µs, Variation ≤ 2V peak to peak. 4 03/10 Rev. 1