Model 6130 series Low Profile 7/8” Diameter Single Turn Conductive Plastic Bronze Bearing Position Sensor Precision Potentiometer MODEL STYLES AVAILABLE 6134 6 mm Shaft, 3/8” Bushing 6137 1/4” Shaft, 3/8” Bushing 6138 for heavy side load applications 1/4” Shaft, 3/8” Bushing 6130-XXX Custom models are available; Contact Customer Service for special features or tolerances ELECTRICAL1 Resistance Range 1K to 100K Ohms Standard Resistance Tolerance ±20% Independent Linearity2 ±1% (±2% for values greater than 20K Ohms) Minimum Practical Independent Linearity ±0.5% Input Voltage 400 VDC maximum, not to exceed power rating Power Rating 1.0 Watt at 70°C, derating to 0 at 125°C Dielectric Strength 750 V rms Insulation Resistance 1,000 Megohms minimum Output smoothness 0.1% maximum Actual Electrical Travel 340° ±3° (300° ±3° with stop feature) Electrical Continuity Travel 350° ±3° (343° ±3° with stop feature) End Voltage maximum 0.5% of input voltage Resolution essentially infinite Temperature Coefficient of Resistance -400 ppm/°C typical Temperature Coefficient of Output Voltage3 ±10 ppm/°C typical MECHANICAL Total Mechanical Travel 360° continuous (343° with stop feature) Weight 0.6 oz. typical Backlash 1° maximum Static Stop Strength 40 in.-oz. maximum Start/Run Torque 0.5 in.-oz. maximum Panel Nut Tightening Torque 25 in. lb. Max. Construction zinc die cast housing, stainless steel shaft, bronze bearing Hazardous Materials 1 2 3 Pb free, E.U. RoHS compliant, no REACH SVHC’s Specifications subject to change without notice. Linearity is measured between 1% and 99% of input voltage. Measured with 10 VDC CW to CCW and slider at 50% of electrical travel BI Technologies Corporation 4200 Bonita Place, Fullerton, CA 92835 USA Phone: 714 447 2345 May 21, 2014 Website: www.bitechnologies.com Model 6130 page 1 of 3 RoHS 2 Pb compliant Model 6130 ENVIRONMENTAL (MIL-PRF-39023) Operating Temperature Range -25°C to +125°C Temperature Cycling (static) 5 cycles, -40°C to +125°C, maximum 15% ΔR Shock 6 ms sawtooth, 100 G’s, 0.1 ms maximum discontinuity Vibration 10 G’s, 10 to 500 Hz, maximum 5% ΔR, 0.1 ms maximum discontinuity Moisture Resistance five 24 hour cycles, maximum 25% ΔR High Temperature Exposure 1,000 hours at 125°C, maximum 0.5% ΔR Rotational Life (model 6137) 5 million shaft revolutions with no sideload Rotational Life (model 6138) 10 million shaft revolutions with up to 16 oz sideload at 90 RPM Ingress Protection Rating (IP Code) IP50 ORDERING INFORMATION 6137 R 10K L1.0 Model Series xx Optional Feature Code (see table) Resistance Prefix Linearity Resistance Value FEATURE CODES Center Tap CT Stop ST Flatted Shaft (slotted is standard) FS When multiple Optional Feature codes are used the P/N shall be in the same sequence as listed in this table (top to bottom). STANDARD RESISTANCE VALUES CIRCUIT DIAGRAM (S) (CCW) 1K 5K 20K 2K 10K 50K (CW) BI Technologies Corporation 4200 Bonita Place, Fullerton, CA 92835 USA Phone: 714 447 2345 May 21, 2014 Website: www.bitechnologies.com Model 6130 page 2 of 3 100K Model 6130 OUTLINE DRAWING BI Technologies Corporation 4200 Bonita Place, Fullerton, CA 92835 USA Phone: 714 447 2345 May 21, 2014 Website: www.bitechnologies.com Model 6130 page 3 of 3