ADAM-6050W ADAM-6051W ADAM-6060W

Wireless LAN-enabled 18-channel
DI/O Module
Wireless LAN-enabled 16-channel
Isolated I/O with Counter Module
Wireless LAN-enabled 6-channel
Relay Output Module
ADAM-6050W
ADAM-6051W
ADAM-6060W
Features
NEW
 Supports IEEE802.11b wireless LAN
 Embedded web server with built-in web page
 Supports Modbus/TCP & UDP protocols
 Supports event trigger function
Introduction
ADAM-6050W, ADAM-6051W, and ADAM-6060W bring wireless LAN communication to your network. The hardware design of the modules were based on ADAM-6050, 6051, and
6060, but a wireless LAN interface has replaced the RJ-45 Ethernet port. With support for the common IEEE802.11b, these modules can be accessed on your wireless LAN without
any hardwiring. A sensible choice for environments with wiring limitations, or expensive wiring requirements.
Specifications
General








Certifications
Connectors
Dimensions (WxHxD)
Enclosure
LAN
LED Indicators
Mounting
Power Consumption
 Power Input
CE, FCC class A
Plug-in screw terminal block (#14 ~ 28 AWG)
70 x 112 x 25 mm
ABS+PC
IEEE802.11b WLAN
Power, communication, signal, strength
DIN 35 rail, stack, wall
ADAM-6050W, ADAM-6060W: 2 W (typical)
ADAM-6051W: 2.5 W
Unregulated 10 ~ 30 VDC
Communications
 Channels
 Counter
 Digital Input
Dry Contact:
Wet Contact
Counter Mode:
Frequency Mode:
 Digital Output
15-12
ADAM-6050W: 12 DI, 6 DO
ADAM-6051W: 12 DI/2 DO/2 Counter
ADAM-6060W: 6 DI, 6 Relay
Maximum Count: 4,294,967,285 (32 bit)
Input frequency: 0.3 ~ 4500 Hz max. (frequency mode)
4500 Hz max. (counter mode)
Modes: Counter (Up/Down, Bi-direction), Frequency
Logic level 0: Close to GND
Logic level 1: Open (Status inversable by utility)
(ADAM-6050W and ADAM-6051W only)
Logic level 0: +3 V (max.)
Logic level 1: +10 to 30 V
Up to 3 kHz for ADAM-6050W/6060W
Up to 4.5 kHz for ADAM-6051W
Up to 3 kHz for ADAM-6050W/6060W
Up to 4.5 kHz for ADAM-6051W
Open collector to 30 V, 200 mA max. load
Pulse output : up to 5 kHz for ADAM-6050W and
ADAM-6051W
Smart Web Ethernet I/O Modules
 Relay Output (Form A) Contact rating: AC: 120 V @ 0.5 A, DC: 30 V @ 1 A
Breakdown voltage: 500 VAC (50/60 Hz)
Relay on time: 7 msec; Relay off time: 3 ms
Total switching time: 10 ms
Insulation resistance: 1 GΩ minimum at 500 VDC
Protection
 Optical Isolation
ADAM-6050W: 5,000 VRMS
ADAM-6051W, ADAM-6060W: 2,000 VRMS
 Power Reversal Protection
Software
 Support Protocol
 Watchdog Timer
 Web Server
Modbus/TCP and UDP
Yes, programmable (Comm.)
Embedded, with web page for configuration
Environment
 Humidity
5 ~ 95 % RH, non-condensing
 Operating Temperature -10 ~ 60 °C (14 ~ 140 °F)
 Storage Temperature -25 ~ 85 °C (-13 ~ 185 °F)
Ordering Information
 ADAM-6050W-A
 ADAM-6051W-A
 ADAM-6060W-A
Wireless LAN-enabled 18-channel DI/O Module
Wireless LAN-enabled 16-channel Isolated I/O with
Counter Module
Wireless LAN-enabled 6-channel Relay Output Module
ADAM-6022
ADAM-6000
Ethernet-based Dual-loop PID Controller
Series Dimensions
Dimensions
Unit: mm
ADAM-6022
Specifications
General
 Dimensions (W x H x D) 70 x 112 x 25 mm
 Loop Number
2 (3 AI, 1 AO, 1 DI, 1 DO
for each control loop)
 Power Consumption
4 W (typical)
 LAN
10/100Base-T
Analog Input
 Accuracy
 Bandwidth





Channels
CMR @ 50/60 Hz
Resolution
Input Impedance
Input Range




Isolation Voltage
Sampling Rate
Span Drift
Zero Drift
±0.1 % or better
13.1 Hz @ 50 Hz
15.72 Hz @ 60 Hz
6 differential
92 dB min.
16 bits
20 MΩ
0 ~ 10 VDC, 0 ~ 20 mA,
4 ~ 20 mA
2,000 VDC
10 samples/sec.
±25 ppm/° C
±6 µV/° C
Analog Output






Accuracy
Channels
Drift
Drive Voltage
Isolation Voltage
Output Range
0.05% of FSR
2
±50 ppm/° C
15 VDC (current output)
2,000 VDC
0 ~10 VDC, 4 ~ 20 mA,
0 ~ 20 mA
12 bits
 Resolution
Ordering Information
 ADAM-6022
Digital Inputs
 Channels
Dry Contact:
2
Logic level 0: close to
GND
logic level 1: open
Logic level 0: +3Vmax
Logic level 1: 10~30 VDC
Wet Contact:
Digital Outputs
 Channels
Environment




15-18
2
Open Collector to 30 V
100 mA max. load
Humidity (Operating)
Humidity (Storage)
Operating Temperature
Storage Temperature
20~95% RH,(non-cond)
0~95% RH, (non-cond.)
-10~50° C
-20~80° C
Smart Web Ethernet I/O Modules
Dual-loop PID
Controller
Software Ordering
Information
 PCLS-OPC/MTP
 AStudio-WNT/DEV
Modbus/TCP OPC
Server
Astudio-WNI/PRO Webenabled HMI/SCADA
Software
ADAM-6050W
ADAM-6051W
ADAM-6060W
Feature Details
Home/Building Application
Communication
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Software
ADAM-6050W, ADAM-6051W and ADAM-6060W support IEEE802.11b, so they can
connect to most wireless LAN access points.
IPPC
Like other ADAM-6000 modules, ADAM-6050W, ADAM-6051W and ADAM-6060W
also support the Modbus/TCP and UDP protocols. You can use HMI/SCADA software to
communicate with the modules through Modbus/TCP. The pre-built UDP protocol supports
event trigger and data streaming functions for critical and real time responses.
TPC
Embedded web server with built-in web page
FPM
The modules have an embedded web server with a built-in webpage that can be configured
by an utility for: Tag Name, Status Label (for example, Start/Stop, Run/Stop, Enable/Disable
and Alarm/Normal), and Channel Enable.
ATM & AWS
Although it is based on Java technology, there is no need to learn how to write Java applets
to design a customized web page. By using ADAM-6000 utility software, the webpage
can be customized to exact requirements.
DA&C
cPCI
Port Crane Monitoring & Control
Application
ADAM-3000
Motion Control
ICOM
Industrial Networking
UNO
ADAM-4000
ADAM-5000
ADAM-6000
ADAM-8000
BAS
Online Download www.advantech.com/products
15-13