NANO840/842 Series Quick Installation Guide CPU Board x1 Quick Installation Guide x1 Product Information CD x1 COM Port Cable with Bracket, P=2.0mm x1 Note: Please contact your local vendors if any damaged or missing items. DO NOT apply power to the board if there is any damaged component. Please refer to the NANO840/842 series product information CD for the complete user’s manual, drivers and utilities. User’s manual and related documents are in Acrobat PDF format. Connectors Bottom View Quick Start The basic procedures required to power on NANO840/842: (1). Require at least 60W DC adapter. Ensure that all necessary peripheral devices are plugged properly. (2). Check the jumper settings and make sure they are in the default position; especially JP6 (close). (3). Firmly install DDR3L memory modules into connector SODIMM until fully seated. (4). Firmly insert the DC adapter into CN16. (5). Install a momentary on/off button/switch onto CN9, pin 9 and 10. See image above. (6). Press the power button to start NANO840/842. 4 9418K840000E ©Copyright 2015 Axiomtek Co., Ltd. Version A1 August 2015 Printed in Taiwan Connector Description CN1 CN2~CN3 CN4 CN5 CN7 CN8 CN9 CN10 CN11 CN12 CN13 CN14 CN16 CN17 CN18 CN19 (Optional) SATA1 SCN1 SCN2 SODIMM Digital I/O Connector COM Connectors SATA Power Connector Fan Connector SMBus Connector Inverter Connector Front Panel Connector LVDS Connector Internal USB 2.0 Port 3 and 6 LAN1, USB 3.0 port 0 and USB 2.0 port 2 LAN2, USB 2.0 port 4 and 5 VGA Connector DC Power Jack Audio Jack HDMI Connector COM2 Connector SATA Connector Full-size PCI-Express Mini Card Connector Half-size PCI-Express Mini Card Connector DDR3L SO-DIMM Socket 9418K840000E ©Copyright 2015 Axiomtek Co., Ltd. Version A1 August 2015 Printed in Taiwan 1 NANO840/842 Nano-ITX Board Checklist Jumper Settings Before applying power to the NANO840/842, please make sure all of the jumpers are in factory default position. Jumper JP1 Description Setting COM1 Data/Power Selection Default: RS-232 Data CN2 Pin 1: DCD 1-3 Close CN2 Pin 8: RI 2-4 Close JP2 JP3 3-5, 4-6 Close COM1 RS-232/422/485 Mode Setting Default: RS-232 JP4 JP6 JP7 JP8 JP10 1-2 Close 3-5, 4-6 Close Auto Power On Default: Disable LVDS Brightness Control Mode Setting Default: PWM Mode LVDS Voltage Selection Default: +3.3V level Restore BIOS Optimal Defaults Default: Normal Operation 1-2 Close 1-2 Close 5-6 Close 1-2 Close Board Layout Top View Side View Side View 2 9418K840000E ©Copyright 2015 Axiomtek Co., Ltd. Version A1 August 2015 Printed in Taiwan 9418K840000E ©Copyright 2015 Axiomtek Co., Ltd. Version A1 August 2015 Printed in Taiwan 3