Packing List Specifications Before you begin installing your card, please make sure that the following materials have been shipped: • 1 PCA-6007 Pentium® 4/Celeron® D / Celeron® processor-based single board computer Standard SBC Functions • CPU: Intel® socket 478 Pentium® 4 up to 3.4GHz FSB 533/ 800MHz, Celeron® D up to 3.06GHz FSB 533MHz, Celeron® up to 2.8GHz FSB 400MHz; supports Intel Hyper Threading technology. CPU with 1.75V core voltage (Willamete) not supported. • BIOS: Award 4 Mb Flash memory BIOS • 1 PCA-6007 Startup Manual • Chipset: Intel 865GV with ICH5 • 1 CD with driver utility and manual (in PDF format) • System Memory: Dual Channel; Four 184-pin DIMM sockets accepts up to 4 GB DDR 266/333/400 SDRAM (PC 2100/2700/ 3200) • 1 FDD cable p/n: 1700340640 • 2 Ultra ATA 66/100 HDD cables p/n: 1701400452 • 2 Serial ATA HDD data cable p/n: 1700071000 • 2 Serial ATA HDD power cable p/n: 1703150102 • 1 ATX 12V power converter cable p/n: 170304015K • 1 Printer (parallel) port & COM port cable kit p/n: 1701260305 • 1 Y cable for PS/2 keyboard and PS/2 mouse p/n: 1700060202 • 1 Two USB port cable (optional) p/n: 1700100170 • SATA/IDE interface: Supports up to two independent Serial ATA hard drives (up to 150MB/s) and two IDE hard disk drives or four enhanced IDE devices. BIOS enabled/disabled. • FDD interface: Supports up to two FDDs • Serial ports: Two serial RS-232 ports • Parallel port: One parallel port, supports SPP/EPP/ECP mode • Keyboard/mouse connector: Supports one standard PS/2 keyboard and mouse • Watchdog timer: 255 level timer intervals • USB (2.0): Maximum up to six Universal Serial Bus ports VGA Interface • Chipset: Intel 865GV integrated • Warranty card • Display memory: Share system memory up to 64 MB, BIOS selectable • Resolution: up to 2048 x 1536 @ 85Hz Ethernet Interface If any of these items are missing or damaged, contact your distributor or sales representative immediately. Note: • Interface: Intel® Extreme Graphics Architecture Acrobat Reader is required to view any PDF file. Acrobat Reader can be downloaded at: www.adobe.com/products/acrobat/readstep2.html • Chipset: • Single 10/100Base-T: Intel 82562EZ Mechanical and Environmental • Dimensions (L x W): 338 x 122 mm • Power supply voltage: +5 V ± 12 V • Power requirements: Typical : +5V:6.53A, +12V:4.57A (Intel Pentium® 4 3.0GHz with 800MHz FSB, 512MB DDR 400 SDRAM) • Operating temperature: 0 ~ 60× C (depending on CPU) For more information on this and other Advantech products, please visit our website at: • Weight: 0.5 kg (weight of board) http://www.advantech.com http://www.advantech.com/eplatform For technical support and service, please visit our support website at: http://service.advantech.com/support This manual is for the PCA-6007 series Rev. A1. Part No. 2002600710 Printed in Taiwan 1st Edition October 2006 PCA-6007 Startup Manual 1 PCA-6007 Full-sized PCI/ISA-bus socket 478 Pentium® 4/Celeron®D/ Celeron® processor-based CPU card PCA-6007 Full-sized PCI/ISA-bus socket 478 Pentium®4/Celeron® D/Celeron®processor-based CPU card Jumpers and Connectors The board has a number of jumpers that allow you to configure your system to suit your application. The table below lists the function of each of the jumpers and connectors. Label J1 J2 Function CMOS clear Watchdog timer output selection Label CN1 CN2 CN3 CN4 CN6 CN7 CN8 CN9 CN10 CN11 CN12 CN13 CN14 CN16 CN17 CN18 CN19 CN20 CN21 CN22 Function Primary IDE connector Secondary IDE connector Floppy drive connector Parallel port USB port 4, 5 VGA connector Ethernet connector 1 Serial port: COM1 Serial port: COM2 PS/2 keyboard and mouse connector External keyboard connector Reserved CPU FAN connector Power LED External speaker Reset connector HDD LED connector ATX feature connector ATX soft power switch HW Monitor Alarm Close: Enable OBS Alarm Open: Disable OBS Alarm AC97 Link connector Serial ATA0 Serial ATA1 ATX 12V Auxiliary power connector CN43 SA0 SA1 ATX1 J1: CMOS clear function Pins Result 1-2 (closed) Keep CMOS data* 2-3 (closed) Clear CMOS 2 PCA-6007 Startup Manual *default setting J2: Watchdog timer output option Closed pins Result 1-2 IRQ11 2-3 System reset * Software Installation • The CD disc contains a driver installer program that will lead you through the installation of various device drivers needed to take full advantage of your CPU card. Caution The computer is provided with a battery-powered Real-time Clock circuit. There is a danger of explosion if battery is incorrectly replaced. Replace only with same or equivalent type recommended by the manufacturer. Discard used batteries according to manufacturer's instructions CN21 CN19 CN17 CN16 CN18 ATX1 CN14 DIMM3 DIMM1 CN30 CN2 CN4 CN43 SA1 SA0 CN20 J2 CN13 J1 CN10 CN12 CN22 CN6 CN9 CN8 CN7 CN11 Board Layout: Jumper and Connector Locations 3 PCA-6007 Startup Manual