PRODUCT DATASHEET 1-800-383-7323 / USA USA/CAN 1-800-383-7323 1-800-383-7323 / CANADA www.energizer.com ENERGIZER 301 SILVER OXIDE Specifications Chemical System: Designation: Nominal Voltage: Typical Capacity: Capacity Test: Typical Weight: Typical Volume: Impedance (40 Hz): Industry Standard Dimensions mm (inches) Silver Oxide (Zn/Ag2O) ANSI-1132SO, IEC-SR43 1.55 Volts 110 mAh* (to 1.3 volts) 8.2K ohm continuous drain at 21°C 1.7 grams (0.06 oz.) 0.44 cubic centimeters (0.027 cubic inch) 10 to 20 ohms * Varies according to the applied load, temperature, and cutoff voltage. Cross Section 6.70 (0.265) Ref. Typical 4.20 (0.165) 11.60 (0.457) 11.25 (0.443) 3.80 (0.150) R1.5 (0.059) Ref. Typical 3.63 (0.143) Ref. 3.38 (0.133) Ref. Anode Cap Gel Anode 0.20 (0.008) Maximum Ref. Permissible deflection from a flat Gasket Can Separator 0.13 (0.005) Minimum Ref. (applies to top edge of gasket or edge of crimp, whichever is higher) Cathode DESIGNED FOR USE ON CONTINUOUS LOW DRAIN Typical Discharge Characteristics Temperature Characteristics Typical Performance at 21°C (70°F) Typical Performance at Low Discharge Rates Service Effects Service (%) 125 1.7 1.6 1.5 1.4 1.3 1.2 1.1 1.0 100 75 50 25 0 -20 0 20 40 Temperature (C) 0 100 200 300 400 500 Service, Hours Schedule Continuous Typical Drains at 1.55V (milliamperes) (ohm) Cutoff 1.3V (hours) 0.189 8.2K 582 Load Storage Effects 600 Service (%) Voltage, CCV Schedule: Continuous Typical Drain @1.55V: 0.189 milliamperes Load: 8.2K ohm 100 0°C 90 20°C 80 70 40°C 60 0 2 4 6 8 10 12 Storage Time (yrs) Important Notice This datasheet contains typical information specific to products manufactured at the time of its publication. ©Energizer Holdings, Inc. - Contents herein do not constitute a warranty. Form No. EBC - 4301D Page 1 of 1