ENERGIZER 186 - Energizer Technical Information

PRODUCT DATASHEET
1-800-383-7323
1-800-383-7323
/ USA USA/CAN
1-800-383-7323
/ CANADA
www.energizer.com
ENERGIZER 186
Miniature Alkaline
Specifications
Industry Standard Dimensions
Chemical System:
Manganese Dioxide (MnO2)
Designation:
Nominal Voltage:
Typical Capacity:
IEC-LR43
1.5 Volts
123 mAh (to 0.9 volts)
Rated at 15K ohms / 21°C (70°F)
1.5 grams (0.05 ounces)
0.40 cubic centimeters (0.05 cubic inch)
Typical Weight:
Typical Volume:
mm (inches)
Cross Section
3.80 (0.150)
Minimum
11.60 (0.457)
4.20 (0.165)
11.30 (0.445)
3.80 (0.150)
R1.5 (0.059) Ref.
Anode Cap
3.55 (0.140)
± 1.5 (0.059 Ref.)
Anode Gel
Gasket
Cathode Can
Separator
0.25 (0.010) Maximum Ref.
Permissible deflection from a flat
0.13 (0.005) Minimum Ref.
(applies to top edge of gasket or
edge of crimp, whicever is higher)
Cathode
Designed for electronic applications which
may require high rate pulses
Typical Discharge Characteristics
Depth of Discharge Test
21°C (70°F)
Percent of rated Capacity at 21°C (70°F)
Load: 15K ohms - Continuous
Typical Drain @ 1.25V: 0.125 mA
Typical closed circuit voltage during discharge
on a load of 100 ohms for 0.1 to 2.0 seconds
1.6
% Rated Capacity
Voltage, CCV
1.5
1.4
0%
40%
80%
1.52V
1.19V
1.07V
1.3
1.2
Bulge Data
1.1
1.0
0.9
0
300
Schedule:
Continuous
600
900
Service, Hours
1200
1500
Load
Typical Drains:
at 1.25V
(milliamperes)
(ohms)
Cutoff
0.9V
(hours)
0.083
15,000
1,476
This battery will bulge as it is discharged but will not exceed the
maximum height shown on the battery drawing.
Important Notice
This data sheet contains typical information specific to products manufactured at the time of its publication.
©Energizer Holdings, Inc. - Contents herein do not constitute a warranty.
Form No. EBC - 4401H
Page 1 of 1