PRODUCT DATASHEET 1-800-383-7323 1-800-383-7323 / USA USA/CAN 1-800-383-7323 / CANADA www.energizer.com ENERGIZER A76 MINIATURE ALKALINE Specifications Chemical System: Designation: Nominal Voltage: Typical Capacity: Capacity Test: Typical Weight: Typical Volume: Impedance (40 Hz): Max Bulge: Industry Standard Dimensions mm (inches) 11.60 (0.457) 11.25 (0.443) 3.80 (0.150) Minimum R1.5 (0.059) Ref. 5.40 (0.213) 4.90 (0.193) Manganese Dioxide (MnO2) ANSI/NEDA 1166A, IEC-LR44 1.5 Volts 150 mAh* (to 0.9 volts) 7.5K ohm continuous drain at 21°C (70°F) 2.4 grams (0.08 oz.) 0.54 cubic centimeters (0.03 cubic inch) 3 to 9 ohms This battery will bulge as it is discharged, but will not exceed the maximum height shown on the battery drawing. * Varies according to the applied load, temperature, and cutoff voltage. Cross Section 4.80 (0.189) Ref. 4.60 (0.181) Ref. 0.25 (0.010) Maximum Ref. Permissible deflection from a flat Anode Cap Gel Anode 0.13 (0.005) Minimum Ref. (applies to top edge of gasket or edge of crimp, whichever is higher) Gasket Can Separator DESIGNED FOR ELECTRONIC APPLICATIONS WHICH MAY REQUIRE HIGH RATE PULSES Cathode Typical Discharge Characteristics Depth of Discharge Typical Performance at 21°C (70°F) Typical Performance at 21°C (70°F) Load: 7.5K ohms - Continuous Typical Drain @ 1.25V: 0.17 mA Hours to 0.9V: 900 Load: 7.5K ohms - Continuous Typical Drain @ 1.25V: 0.17 mA Hours to 0.9V: 900 1.6 (as percent of capacity) Voltage, CCV 1.5 1.4 1.3 Temperature 0% 40% 80% 1.2 21°C (70°F) 1.55V 1.33V 1.20V 1.1 1.0 0.9 0 200 400 600 Service, Hours 800 1000 Important Notice This datasheet contains typical information specific to products manufactured at the time of its publication. ©Energizer Holdings, Inc. - Contents herein do not constitute a warranty. Form No. EBC - 4407F Page 1 of 1