PRODUCT DATASHEET 1-800-383-7323 / USA + 44 (0) 208 920 2306 1-800-383-7323 / CANADA www.energizer-eu.com ENERGIZER EPX76 SILVER OXIDE Specifications Chemical System: Designation: Nominal Voltage: Typical Capacity: Capacity Test: Typical Weight: Typical Volume: Impedance (40 Hz): Industry Standard Dimensions mm (inches) Silver Oxide (Zn/Ag2O) ANSI-1107SO, IEC-SR44 1.55 Volts 200 mAh* (to 0.9 volts) 6.8K ohm continuous drain at 21°C 2.3 grams (0.08 oz.) 0.57 cubic centimeters (0.035 cubic inch) 3 to 10 ohms * Varies according to the applied load, temperature, and cutoff voltage. 7.20 (0.283) Ref. Typical 11.60 (0.457) 11.25 (0.443) Cross Section 5.40 (0.213) 5.00 (0.197) 4.83 (0.190) Ref. 4.57 (0.180) Ref. R1.5 (0.059) Ref. Typical Anode Cap Gel Anode Gasket Can Separator 0.20 (0.008) Maximum Ref. Permissible deflection from a flat 0.13 (0.005) Minimum Ref. (applies to top edge of gasket or edge of crimp, whichever is higher) Cathode DESIGNED SPECIFICALLY FOR PHOTO USE Typical Discharge Characteristics Temperature Characteristics Typical Performance at 21°C (70°F) Typical Performance at Low Discharge Rates Service Effects Schedule: Continuous Typical Drain @1.40V: 0.206 milliamperes Load: 6.8K ohm Service (%) 125 1.5 75 50 25 0 1.3 -20 0 1.1 20 40 Temperature (C) 0.9 0 200 400 600 800 Service, Hours Schedule Typical Drains at 1.40V (milliamperes) (ohm) Cutoff 0.9V (hours) 0.206 6.8K 971 Continuous Load Storage Effects 1000 100 Service (%) Voltage, CCV 1.7 100 0°C 90 20°C 80 70 40°C 60 0 2 4 6 8 10 12 Storage Time (yrs) Important Notice This datasheet contains typical information specific to products manufactured at the time of its publication. ©Energizer Holdings, Inc. - Contents herein do not constitute a warranty. Form No. EBC - 4347F-ZEU Page 1 of 1