PRODUCT DATASHEET 1-800-383-7323 + 44 (0) / USA 208 920 2306 1-800-383-7323 / CANADA www.energizer-eu.com ENERGIZER 333 SILVER OXIDE Specifications Industry Standard Dimensions mm (inches) Chemical System: Silver Oxide (Zn/Ag2O) Nominal Voltage: Typical Capacity: Capacity Test: Typical Weight: Typical Volume: Impedance (40 Hz): 1.55 Volts 5.3 mAh* (to 1.2 volts) 150K ohm continuous drain at 21°C 0.17 grams 0.038 cubic centimeters 30 to 40 ohms * Varies according to the applied load, temperature, and cutoff voltage. 4.90 (0.193) Ref. 6.80 (0.268) 4.30 (0.169) Ref. 6.65 (0.262) 1.05 (0.041) R0.60 (0.024) Ref. 0.90 (0.035) R0.20 (0.008) Ref. 1.05 (0.041) Ref. Cross Section Anode Cap Gel Anode 0.85 (0.033) Ref. Gasket Can Separator 0.13 (0.005) Maximum Ref. Permissible deflection from a flat 0.01 (0.0004) Minimum Ref. (applies to top edge of gasket or edge of crimp, whichever is higher) Cathode DESIGNED FOR USE ON CONTINUOUS LOW DRAIN Typical Discharge Characteristics Temperature Characteristics Typical Performance at 21°C (70°F) Typical Performance at Low Discharge Rates Service Effects Service (%) 125 1.7 1.6 1.5 1.4 1.3 1.2 1.1 1.0 100 75 50 25 0 -20 0 100 Schedule Continuous 200 300 400 Service, Hours 500 Typical Drains at 1.55V (milliamperes) (ohm) Cutoff 1.2V (hours) 0.01 150K 530 Load 0 20 Temperature (C) 40 Storage Effects 600 100 Service (%) Voltage, CCV Schedule: Continuous Typical Drain @1.55V: 0.01 milliamperes Load: 150K ohm 0 C 90 20 C 80 70 40 C 60 0 2 4 6 8 Storage Time (yrs) 10 12 Important Notice This datasheet contains typical information specific to products manufactured at the time of its publication. ©Energizer Holdings, Inc. - Contents herein do not constitute a warranty. rm No. EBC - 8863EU Page 1 of 1