PRODUCT DATASHEET 1-800-383-7323 / USA + 44 (0) 208 920 2306 1-800-383-7323 / CANADA www.energizer-eu.com ENERGIZER 395/399 SILVER OXIDE Specifications Chemical System: Designation: Nominal Voltage: Typical Capacity: Capacity Test: Typical Weight: Typical Volume: Impedance (40 Hz): Industry Standard Dimensions mm (inches) Silver Oxide (Zn/Ag2O) ANSI-1162SO/1165SO, IEC-SR57 1.55 Volts 51 mAh* (to 1.2 volts) 22K ohm continuous drain at 21°C 0.8 grams (0.03 oz.) 0.19 cubic centimeters (0.012 cubic inch) 10 to 25 ohms * Varies according to the applied load, temperature, and cutoff voltage. 3.80 (0.150) Minimum 9.50 (0.374) Cross Section 2.70 (0.106) 9.15 (0.360) 2.40 (0.094) 2.41 (0.095) Ref. R0.70 (0.028) Ref. Typical 2.16 (0.085) Ref. Anode Cap Gel Anode 0.25 (0.010) Maximum Ref. Permissible defelection from a flat Gasket Can Separator 0.03 (0.001) Minimum Ref. (applies to top edge of gasket or edge of crimp, whichever is higher) Cathode DESIGNED FOR USE ON CONTINUOUS LOW DRAIN HIGH PULSE ON DEMAND Typical Discharge Characteristics Temperature Characteristics Typical Performance at 21°C (70°F) Typical Performance at Low Discharge Rates Service Effects Service (%) 125 1.7 1.6 1.5 1.4 1.3 1.2 1.1 1.0 100 75 50 25 0 -20 0 20 40 Temperature (C) 0 200 400 600 Service, Hours Schedule Continuous Typical Drains at 1.52V (milliamperes) (ohm) Cutoff 1.2V (hours) 0.069 22K 752 Load Storage Effects 800 100 Service (%) Voltage, CCV Schedule: Continuous Typical Drain @1.52V: 0.069 milliamperes Load: 22K ohm 0°C 90 20°C 80 70 40°C 60 0 2 4 6 8 Storage Time (yrs) 10 12 Important Notice This datasheet contains typical information specific to products manufactured at the time of its publication. ©Energizer Holdings, Inc. - Contents herein do not constitute a warranty. Form No. EBC - 4362B-ZbEU Page 1 of 1