PRODUCT DATASHEET 1-800-383-7323 / USA + 44 (0) 208 920 2306 1-800-383-7323 / CANADA www.energizer-eu.com ENERGIZER 317 SILVER OXIDE Specifications Industry Standard Dimensions mm (inches) Chemical System: Silver Oxide (Zn/Ag2O) Nominal Voltage: Typical Capacity: Capacity Test: Typical Weight: Typical Volume: Impedance (40 Hz): 1.55 Volts 11.5 mAh* (to 1.2 volts) 68K ohm continuous drain at 21°C 0.17 grams (0.006 oz.) 0.04 cubic centimeters (0.002 cubic inch) 55 to 65 ohms * Varies according to the applied load, temperature, and cutoff voltage. 3.90 (0.154) Ref. Typical 5.80 (0.228) 5.65 (0.222) 1.65 (0.065) Cross Section 1.45 (0.057) R0.9 (0.035) Ref. Typical 1.60 (0.063) Ref. 1.40 (0.055) Ref. Anode Cap Gel Anode 0.13 (0.005) Minimum Ref. Permissible deflection from a flat Gasket Can Separator 0.02 (0.001) Minimum Ref. (applies to top edge of gasket or edge of crimp, whichever is higher) Cathode DESIGNED FOR USE ON CONTINUOUS LOW DRAIN Typical Discharge Characteristics Temperature Characteristics Typical Performance at 21°C (70°F) Typical Performance at Low Discharge Rates Service Effects Service (%) 125 1.7 1.6 1.5 1.4 1.3 1.2 1.1 1.0 100 75 50 25 0 -20 0 20 40 Temperature (C) 0 150 300 450 Service, Hours Schedule Typical Drains at 1.55V (milliamperes) (ohm) Cutoff 1.2V (hours) 0.023 68K 505 Continuous Load Storage Effects 600 100 Service (%) Voltage, CCV Schedule: Continuous Typical Drain @1.55V: 0.023 milliamperes Load: 68K ohm 0°C 90 20°C 80 70 40°C 60 0 2 4 6 8 Storage Time (yrs) 10 12 Important Notice This datasheet contains typical information specific to products manufactured at the time of its publication. ©Energizer Holdings, Inc. - Contents herein do not constitute a warranty. Form No. EBC - 4307G-ZEU Page 1 of 1