PRODUCT DATASHEET 1-800-383-7323 + 44 (0) / USA 208 920 2306 1-800-383-7323 / CANADA www.energizer-eu.com ENERGIZER 373 SILVER OXIDE Specifications Chemical System: Designation: Nominal Voltage: Typical Capacity: Capacity Test: Typical Weight: Typical Volume: Impedance (40 Hz): Industry Standard Dimensions mm (inches) Silver Oxide (Zn/Ag2O) IEC-SR68 1.55 Volts 30 mAh* (to 1.2 volts) 30K ohm continuous drain at 21°C 0.50 grams 0.12 cubic centimeters 40 to 50 ohms * Varies according to the applied load, temperature, and cutoff voltage. 3.80 (0.150) Minimum 1.65 (0.065) 9.50 (0.374) 9.25 (0.364) Cross Section 1.45 (0.057) R0.80 (0.031) Ref. Typical 1.60 (0.063) Ref. 1.40 (0.055) Ref. Anode Cap Gel Anode 0.15 (0.006) Maximium Ref. Permissible deflection from a flat Gasket Can Separator 0.03 (0.001) Minimum Ref. (applies to top edge of gasket or edge of crimp, whichever is higher) Cathode DESIGNED FOR USE ON CONTINUOUS LOW DRAIN Typical Discharge Characteristics Temperature Characteristics Typical Performance at 21°C (70°F) Typical Performance at Low Discharge Rates Service Effects Service (%) 125 1.7 1.6 1.5 1.4 1.3 1.2 1.1 1.0 100 75 50 25 0 -20 0 150 Schedule Continuous 300 Service, Hours 450 Typical Drains at 1.55V (milliamperes) (ohm) Cutoff 1.2V (hours) 0.052 30K 577 Load 0 20 Temperature (C) 40 Storage Effects 600 100 Service (%) Voltage, CCV Schedule: Continuous Typical Drain @1.55V: 0.052 milliamperes Load: 30K ohm 0 C 90 20 C 80 70 40 C 60 0 2 4 6 8 Storage Time (yrs) 10 12 Important Notice This datasheet contains typical information specific to products manufactured at the time of its publication. ©Energizer Holdings, Inc. - Contents herein do not constitute a warranty. Form No. EBC - 8877EU-A Page 1 of 1