S07A THRU S07M A THRU S07 M S07 S07A S07M 1.0 AMP. SURFACE MOUNT GENERAL PURPOSE SILICON RECTIFIERS SOD-123FL FEATURES ·Glass passivated device ·Ideal for surface mouted applications ·Low reverse leakage ·Metallurgically bonded construction ·High temperature soldering guaranteed: 250℃/10 seconds at terminals. MECHANICAL DATA ·Case: JEDEC SOD-123FL,molded plastic over passivated chip ·Terminals:Solder Plated, solderable per MIL-STD-750, Method 2026 ·Polarity: Color band denotes cathode end ·Weight: 0.006 ounces, 0.02 gram ·Mounting position: Any MAXIMUM RATINGS AND ELECTRONICAL CHARACTERISTICS Ratings at 25℃ ambient temperature unless otherwise specified.Single phase, half wave, 60Hz,resistive or inductive load. For capacitive load, derate current by 20%. BOL S07A S07 B S07 D S07 G S07 K S07 M SYM SYMBOL S07B S07D S07G S07JJ S07 S07K S07M Type Number marking SA SB SD SG SJ SK SM Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward rectified Current at TA =65°C (Note 1) VRRM VRMS VDC units 50 100 200 400 600 800 1000 V 35 70 140 280 420 560 700 V 50 100 200 400 600 800 1000 V IF(AV) 1.0 A IFSM 25 A VF 1.1 V Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rate load (JEDEC method) Maximum Instantaneous forward Voltage at 1.0A DC Maximum DC Reverse Current @TA =25°C at rated DC blocking voltage @TA =125°C Typical Junction Capacitance (Note 2) Typical thermal resistance (Note 3) Storage Temperature Range Operation Temperature Range 5.0 IR 100.0 CJ R(JA) TSTG TJ Note: 1.Averaged over any 20 ms period. 2.Measured at 1MHz and applied reverse voltage of 4.0 volts d.c. 3.Measured on P.C.Board with 0.2×0.2”(5.0×5.0mm)Copper Pad Areas 1 µA 4 pF 180 °C /W -55 to +150 °C -55 to +150 °C S07A THRU S07M RATING AND CHARACTERISTIC CURVES (S07A THRU S07M S07M)) 2