Model 1615-20 Chip Attenuator 100 Watts, 20 dB Description The 1615-20 is high performance Aluminum Nitride (AlN) Chip attenuator intended as a cost competitive alternative to Beryllium Oxide (BeO). The attenuator is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The Attenuator is also RoHS compliant! General Specifications Thick film AlN Ceramic Matte Tin over Nickel Barrier -55 to +200°C (see de rating chart) • RoHS Compliant Resistive Element Substrate Terminal Finish Operating Temperature • 100 Watts Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. Features: • DC – 2.3 GHz • AlN Ceramic • Non-Nichrome Resistive Element • Low VSWR • 100% Tested Electrical Specifications Attenuation Value: Power: Frequency Range: VSWR 20 dB ± 1.0 dB 100 Watts DC – 2.3 GHz 1.25 : 1 Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change. Outline Drawing UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN INCHES. TOLERANCES ON DECIMALS .XXX ± .010 1615-20 pg.1 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model 1615-20 Typical Performance: RETURN LOSS ATTENUATION Power De-rating: *Actual performance could be limited by the solder properties of the application Mounting Procedure: 1615-20 pg.2 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392