Model A150N50X4C Chip Termination 150 Watts, 50Ω Description The A150N50X4C is high performance Aluminum Nitride (AlN) chip termination intended as a cost competitive alternative to Beryllium Oxide (BeO). It is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling makes the part ideal for terminating circulators, and for use in power combiners. The termination is also RoHS compliant! General Specifications • 150 Watts Resistive Element Substrate Terminal Finish Operating Temperature • DC – 3.0 GHz Tolerance is ±0.010”, unless otherwise specified. Designed to meet or exceed applicable portions of MIL-E-5400. All dimensions in inches. Features: • RoHS Compliant • AlN Ceramic • Non-Nichrome Resistive Element • Low VSWR • 100% Tested Thick film AlN Ceramic Matte Tin over Nickel Barrier -55 to +150°C (see de rating chart) Electrical Specifications Resistance Value: Power: Frequency Range: Return Loss 50 Ohms, ± 2% 150 Watts DC – 3.0 GHz >26dB Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change. Outline Drawing A150N 50X4C UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN INCHES (mm) pg1 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model A150N50X4C Typical Performance: A150N50X4C Power Derating: A150N50X4C Suggested Mounting procedures: *Actual performance could be limited by the solder properties of the application pg2 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392