RoHS Power Chip Inductors Dimensions: Inches (mm) PC25 0.335 MAX. (8.51) 0.205±0.019 (5.21±0.48) 0.197±0.02 (5.00±0.51) 0.055±0.12 (1.40±3.05) 0.118±0.008 (3.00±0.20) 0.228±0.010 (5.79±0.25) Inductance (µh) Tolerance (%) Test Freq. (MHz) DCR Max. (Ω) *Rated Current (A) PC25-100M-RC 10 20 2.52 0.10 1.44 PC25-120M-RC 12 20 2.52 0.12 1.40 PC25-150M-RC 15 20 2.52 0.14 1.30 PC25-180M-RC 18 20 2.52 0.15 1.23 PC25-220M-RC 22 20 2.52 0.18 1.11 PC25-270M-RC 27 20 2.52 0.20 0.97 PC25-330L-RC 33 15 2.52 0.23 0.88 PC25-390L-RC 39 15 2.52 0.32 0.80 PC25-470L-RC 47 15 2.52 0.37 0.72 PC25-560K-RC 56 10 2.52 0.42 0.68 PC25-680K-RC 68 10 2.52 0.46 0.61 PC25-820K-RC 82 10 2.52 0.60 0.58 PC25-101K-RC 100 10 1KHz 0.70 0.52 PC25-121K-RC 120 10 1KHz 0.93 0.48 PC25-151K-RC 150 10 1KHz 1.10 0.40 PC25-181K-RC 180 10 1KHz 1.38 0.38 PC25-221K-RC 220 10 1KHz 1.57 0.35 Allied Part Number *Inductance drop no more than 10% at rated current applied or temperature rise ∆ T = 40°C. All specifications subject to change without notice. 714-665-1140 ALLIED COMPONENTS INTERNATIONAL 15 Features • Small size allows for high mounting density • Suitable for Reflow Solder • Large DC current capability with low DC resistance • Embossed carrier tape available • Polarity identification available • Custom inductances available Characteristics Operating Temp.: -30° to +100°C. External Appearance: Clean & no external defects by visual inspection Terminal Strength: After soldering, push the coils will withstand the followings without falling off. 20.0N 20 sec. Heat Endurance: Heat at 150°C for 3 minutes; then 200°C for 25 seconds. No mechanical or electrical defect after that when back at room temperature. Insulation: Over 100M ohm at 100 VDC (coil and core). Dielectric: 100VDC for one minute (coil and core). Temperature Characteristics: (0 to 2000) x 10 -6°C. Environmental Humidity: Deviate +/-5%, after 96 hours in 90-95% relative humidity at 40°C and 1 hour of drying. Vibration: Deviate +/-5%, vibration of 1 hour, three direction; 10-55-10 Hz; 1.5mm p-p amplitude. Shock: Deviate 5% after drop down 100G shock attitude of one time in each direction. Physical Packaging: 1000 per 13 inch reel. www.alliedcomponents.com