Typical Performance Characteristics www.vishay.com Vishay Sprague TH5 Tantalum Capacitors ELECTRICAL PERFORMANCE CHARACTERISTICS ITEM PERFORMANCE CHARACTERISTICS Category temperature range -55 °C to +200 °C Category voltage Category voltage is the same within entire temperature range and is equal to rated voltage Capacitance tolerance ± 20 %, ± 10 %, tested via bridge method, at 25 °C, 120 Hz Dissipation factor Limits per Standard Ratings table. Tested via bridge method, at 25 °C, 120 Hz ESR Limits per Standard Ratings table. Tested via bridge method, at 25 °C, 100 kHz Leakage current After application of rated voltage applied to capacitors for 5 min using a steady source of power with 1 k resistor in series with the capacitor under test, leakage current at 25 °C is not more than described in Standard Ratings table. Note that the leakage current varies with temperature and applied voltage. ENVIRONMENTAL PERFORMANCE CHARACTERISTICS ITEM CONDITION POST TEST PERFORMANCE Life test 500 h application of rated voltage at 200 °C Capacitance change Dissipation factor ESR Leakage current -30 % / +10 % of initially specified value Not to exceed 150 % of initial Not to exceed 125 % of initial Not to exceed 1 mA (at 200 °C) Moisture resistance Cycled, 20 cycles, MIL-STD-202, method 106 Capacitance change Dissipation factor Leakage current ± 15 % of initially specified value Not to exceed 150 % of initial Not to exceed 200 % of initial Surge voltage 85 °C, 1000 cycles at 1.3 rated voltage in series with 33 resistor, MIL-PRF-55365 Capacitance change Dissipation factor Leakage current ± 5 % of initially specified value Initial specified value or less Initial specified value or less Note • All measurements to be performed after 24 h conditioning at room temperature. MECHANICAL PERFORMANCE CHARACTERISTICS ITEM CONDITION POST TEST PERFORMANCE Terminal strength / Shear stress test Method: AEC-Q200-006, conditions: pressure load of 5 N for 10 s ± 1 s There shall be no mechanical or visual damage and the components shall meet the original electrical requirements Vibration MIL-STD-202, method 204, condition D, 10 Hz to 2000 Hz, 20 g peak There shall be no mechanical or visual damage and the components shall meet the original electrical requirements Resistance to solder heat MIL-STD-202, method 210, condition K Capacitance change Dissipation factor Leakage current ± 5 % of initially specified value Initial specified value or less Initial specified value or less There shall be no mechanical or visual damage to capacitors post-conditioning. Solderability MIL-STD-202, method 208, ANSI / J-STD-002, test B Applies only to solder and tin plated terminations. Does not apply to gold terminations. All terminations shall exhibit a continuous solder coating free from defects for a minimum of 95 % of the critical area of any individual termination Resistance to solvents MIL-STD-202, method 215 Marking has to remain legible, no degradation of encapsulation material Flammability Encapsulation materials meet UL 94 V-0 with an oxygen index of 32 % Note • All measurements to be performed after 24 h conditioning at room temperature. Revision: 28-Jan-15 Document Number: 40206 1 For technical questions, contact: [email protected] THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000