QB-445 Compliance Matrix 2.5 – 3.5 GHz, 1 Watt Amplifier (Replaces QB-963) A. Electrical Ratings (1) Specifications Typical 25ºC Guaranteed 0ºC to +50ºC Item # A.1 Parameter Frequency Range Unit GHz A.2 Small Signal Gain dB 32 32.0 ± 1.5 Comply A.3 Gain Flatness dB ± 0.25 ± 0.50 max. Comply A.4 Input VSWR 1.5 :1 2.0 :1 max. Comply A.5 Output VSWR 1.5 :1 2.0 :1 max. Comply A.6 Reverse Isolation dB 53 42 min. Comply A.7 Noise Figure dB 3.5 5.0 max. Comply A.8 Pout @ 1dB Compression dBm +33.5 +33 Comply +45 +45 Comply rd A.9 3 Order Output Intercept Point dBm A.10 DC Voltage Vdc A.11 Operating DC Current mA 2.5 – 3.5 +15.0 1000 Comments Comply Comply 1500 max. Comply Notes: 1) 2) Specification ratings are based on measurements in a 50 ohm system with a DC supply voltage tolerance of ± 1%. RF output terminated into 50 ohms (Load VSWR ≤ 2.0 : 1). B. Absolute Maximum Ratings Item # B.1 Parameter DC Voltage @ 25°C Limit Max. Unit Vdc Specification +16.0 Comments Comply B.2 Input Drive @ 25°C Operating Temperature* B.4 Storage Temperature dBm ºC ºC ºC ºC +10 - 20 +85 - 55 +125 Note 2 B.3 Max. Min. Max. Min. Max. Comply Comply * Maximum Operating Temperature is defined as that temperature which, if exceeded for extended periods, could result in premature unit failure. This data is provided for user reliability information. This may or may not represent the maximum temperature for electrical parameter specifications. C. General Item # C.1 Parameter Package (Hermetic) Specification SMI Drawing 080-22859 (Figure 1) Comments 70/30 CuNi CuNi (Copper Nickel Alloy) Comply SMA Female (2 Hole Flange) Field Replaceable C.2 Finish C.3 RF Input / Output Connectors C.4 +VDC Connector Gold Plated Pin Solderable C.5 Ground Terminal Threaded Turret Solderable Revision 1 D. Package Outline NOTES: • • • • INTERPRET DRAWING IAW ASME Y14.100-2004 DIMENSIONING AND TOLERANCING IAW ASME Y14.5-1994 DIMENSIONS ARE IN INCHES MATERIAL: 70/30 COPPER NICKEL TOLERANCES • • • ANGLES: ± 1.0° 2 PLACE DECIMAL: ± .03 inches 3 PLACE DECIMAL: ± .010 inches Figure 1 Revision 1