EMG3 / UMG3N / FMG3A Transistors Emitter common (dual digital transistors) EMG3 / UMG3N / FMG3A zExternal dimensions (Unit : mm) zFeatures 1) Two DTC143T chips in a EMT or UMT or SMT package. 2) Mounting cost and area can be cut in half. 0.22 (2) (1) 1.2 1.6 0.5 0.13 (5) zStructure Dual NPN digital transistor (each with a single built in resistors) (3) (4) 0.5 0.5 1.0 1.6 EMG3 Each lead has same dimensions ROHM : EMT5 Abbreviated symbol : G3 The following characteristics apply to both the DTr1 and DTr2. 1.3 (2) (1) 2.0 (3) (4) 0.2 (5) zEquivalent circuit 0.65 0.65 UMG3N 1.25 (2) (4) (1) R1=4.7kΩ R1 DTr1 (3) (4) (2) (5) 0.1Min. (5) R1=4.7kΩ R1 DTr1 R1 DTr2 0.9 0.7 FMG3A 0to0.1 (3) R1 DTr2 0.15 2.1 EMG3 / UMG3N Each lead has same dimensions ROHM : UMT5 EIAJ : SC-88A (1) Abbreviated symbol : G3 Unit 2.9 Limits 1.1 Symbol 0.95 0.95 1.9 Parameter (5) (1) (4) zAbsolute maximum ratings (Ta = 25°C) 0.8 (3) (2) 0.3 FMG3A 1.6 VCBO 50 V Collector-emitter voltage VCEO 50 V Emitter-base voltage VEBO 5 V Collector current Collector EMG3, UMG3N power dissipation FMG3A IC PC 100 150 (TOTAL) 0.3to0.6 mA mW 300 (TOTAL) Junction temperature Tj 150 ˚C Storage temperature Tstg −55 to +150 ˚C ∗1 ∗2 0to0.1 Collector-base voltage 0.15 2.8 Each lead has same dimensions ROHM : SMT5 EIAJ : SC-74A Abbreviated symbol : G3 ∗1 120mW per element must not be exceeded. ∗2 200mW per element must not be exceeded. Rev.A 1/2 EMG3 / UMG3N / FMG3A Transistors zElectrical characteristics (Ta = 25°C) Parameter Symbol Min. Typ. Max. Unit Conditions Collector-base breakdown voltage BVCBO 50 − − V IC=50µA Collector-emitter breakdown voltage BVCEO 50 − − V IC=1mA Emitter-base breakdown voltage BVEBO 5 − − V IE=50µA ICBO − − 0.5 µA VCB=50V Collector cutoff current IEBO − − 0.5 µA VEB=4V VCE (sat) − − 0.3 V IC/IB=5mA/0.25mA hFE 100 250 600 − VCE=5V, IC=1mA fT − 250 − R1 3.29 4.7 6.11 Emitter cutoff current Collector-emitter saturation voltage DC current transfer ratio Transition frequency Input resistance MHz VCE=10V, IE= −5mA, f=100MHz ∗ − kΩ ∗ Transition frequency of the transistor zPackaging specifications Package Type Taping Code T2R TR T148 Basic ordering unit (pieces) 8000 3000 3000 EMG3 UMG3N FMG3A 1k VCE=5V DC CURRENT GAIN : hFE 500 200 Ta=100˚C 25˚C −40˚C 100 50 20 10 5 2 1 100µ 200µ 500µ 1m 2m 5m 10m 20m 50m100m COLLECTOR CURRENT : IC (A) Fig.1 DC current gain vs. collector current COLLECTOR SATURATION VOLTAGE : VCE (sat) (V) zElectrical characteristic curves 1 lC/lB=20 500m 200m Ta=100˚C 25˚C −40˚C 100m 50m 20m 10m 5m 2m 1m 100µ 200µ 500µ 1m 2m 5m 10m 20m 50m 100m COLLECTOR CURRENT : IC (A) Fig.2 Collector-emitter saturation voltage vs. collector current Rev.A 2/2 Appendix Notes No technical content pages of this document may be reproduced in any form or transmitted by any means without prior permission of ROHM CO.,LTD. The contents described herein are subject to change without notice. The specifications for the product described in this document are for reference only. Upon actual use, therefore, please request that specifications to be separately delivered. Application circuit diagrams and circuit constants contained herein are shown as examples of standard use and operation. Please pay careful attention to the peripheral conditions when designing circuits and deciding upon circuit constants in the set. Any data, including, but not limited to application circuit diagrams information, described herein are intended only as illustrations of such devices and not as the specifications for such devices. ROHM CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any third party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or connected with or related to the use of such devices. Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or otherwise dispose of the same, no express or implied right or license to practice or commercially exploit any intellectual property rights or other proprietary rights owned or controlled by ROHM CO., LTD. is granted to any such buyer. Products listed in this document are no antiradiation design. The products listed in this document are designed to be used with ordinary electronic equipment or devices (such as audio visual equipment, office-automation equipment, communications devices, electrical appliances and electronic toys). Should you intend to use these products with equipment or devices which require an extremely high level of reliability and the malfunction of with would directly endanger human life (such as medical instruments, transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other safety devices), please be sure to consult with our sales representative in advance. About Export Control Order in Japan Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control Order in Japan. In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause) on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction. Appendix1-Rev1.1