English User's Manual

Operation
User's Guide
Getting Started
1.
Open the battery compartment by sliding the battery compartment cover off in the direction of the arrow (rear of meter). Remove
the battery safety strip. The displays should switch on. If the displays do not switch on, replace the battery. Replace the battery
compartment cover.
2.
Remove the clear protective decal from the meter’s displays.
Selecting oC/oF units of measure and the 12/24 clock modes
Use the oC/oF slide switch on the back of the meter to select the desired temperature unit of measure. When the instrument is
programmed for oF temperature operation, the clock will be in the 12-hour mode. When the instrument is programmed for oC temperature
operation, the clock will be in the 24-hour (military time) mode.
Hygro-Thermometer Clock
MAX-MIN Record and Recall Operation
Model 445702
Hygro–Thermometer Cloc k
Introduction
Congratulations on your purchase of the Extech 445702 Hygro-Thermometer Clock. This instrument displays Time (12/24 hour clock),
Temperature (C or F), and Relative Humidity % simultaneously. The housing can be wall mounted or placed on a table-top using the
built-in tilt stand. Features include MIN/MAX displays and programmable Alarm Clock. Careful use of this device will provide years of
reliable service.
Specifications
Three LCD views for Time, Temperature, & Relative Humidity
Ranges
Temperature: -10 to 60oC (14 to 140oF); Relative Humidity: 10 to 85%
Resolution
Accuracy
Temperature:
Humidity: 1%
Humidity: ± 6% in the 25 to 80% range & from 0 to
50oC
(32 to
122oF)
Temperature: ± 1oC from -10 to 50oC and ± 1.8oF from 14 to 122oF
Power supply
One (1) ‘AAA’ 1.5V Battery
Low Battery
Battery icon appears on the lower LCD when the battery is to be replaced
Dimensions
109 x 71 x 20mm (4.3 x 2.8 x 0.8")
Weight
Approx. 113g (4 oz.) with battery
Description
Press MAX/MIN. The highest readings recorded since the Reset button was pressed appear in the display.
2.
Press the MAX/MIN button again to display the lowest values since the Reset button was last pressed.
3.
Press the RESET button while in the MAX-MIN display to clear the memory and start recording new MAX-MIN values.
4.
Press the MAX/MIN button again to return to normal display operation.
Setting the Clock
1.
Press and hold the CLOCK button until the hour digits begin to flash
2.
Use the ADVANCE button to set the hour
3.
Press the CLOCK button again; the minutes digits will begin to flash
4.
Use the ADVANCE button to set the minutes
5.
Press the CLOCK button to exit the time setting mode
Setting the Alarm Clock
Display
0.1o C/F;
1.
1.
Press the RESET/AL button. The CLK ALARM icon appears on the lowest LCD display and the hours digits will flash.
2.
Press the AL/ON OFF button on the rear of the instrument. The alarm BELL icon will appear on the top LCD display. Press the
AL/ON OFF button again if you wish to disable the alarm (alarm bell icon will switch off).
3.
Use the ADVANCE button to select the alarm hour.
4.
Press the RESET/AL button again; the minutes digits will flash.
5.
Use the ADVANCE button to select the alarm minutes.
6.
Press the RESET/AL button to exit. The CHK ALARM icon will switch off and the bell icon will remain on.
7.
When the clock time equals the alarm time, the buzzer will sound for 1 minute.
8.
To silence the buzzer, press any button on the instrument.
You, as the end user, are legally bound (Battery ordinance) to return all used batteries and accumulators;
disposal in the household garbage is prohibited!
1.
2.
Clock display
Temperature display
3.
Humidity display
You can hand over your used batteries / accumulators at collection points in your community or wherever
batteries / accumulators are sold!
4.
5.
Temp/Humidity Sensor
MAX / MIN button
6.
RESET / AL (Alarm) button
Disposal: Follow the valid legal stipulations in respect of the disposal of the device at the end of its
lifecycle
7.
8.
9.
CLOCK button
ADVANCE button
Alarm on-off switch
10.
Alarm speaker
11.
12.
Tilt Stand
Battery compartment
13.
Temperature units switch
14.
Wall mount
Copyright © 2009 Extech Instruments Corporation.
All rights reserved including the right of reproduction in whole or in part in any form.
445702 V3.1 7/09