UNISONIC TECHNOLOGIES CO., LTD U74LVC1G126 CMOS IC BUS BUFFER/LINE DRIVER; 3-STATE DESCRIPTION The U74LVC1G126 is single bus buffer/line driver with 3-state output. The output is disabled When the output enable (OE) is low. When OE is high, true data is will pass A input to the Y output. This device has power-down protective circuit preventing device from destruction when it is powered down. FEATURES * Operate From 1.65V to 5.5V * Inputs Accept Voltages to 5.5V * High Noise Immunity * Low Power Dissipation * Direct Interface With TTL level ORDERING INFORMATION Ordering Number U74LVC1G126G-AE5-R U74LVC1G126G-AF5-R U74LVC1G126G-AL5-R Package SOT-23-5 SOT-25 SOT-353 Packing Tape Reel Tape Reel Tape Reel MARKING www.unisonic.com.tw Copyright © 2015Unisonic Technologies Co., Ltd 1 of 5 QW-R502-398.D U74LVC1G126 CMOS IC PIN CONFIGURATION VCC 5 1 OE Y 4 2 A 3 GND FUNCTION TABLE INPUT(OE) INPUT(A) OUTPUT(Y) H L L H H H L X Z Note: H: HIGH voltage level; L: LOW voltage level; X=don’t care; Z=high-impedance OFF-state. LOGIC DIAGRAM (Positive Logic) Logic Symbol UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw IEC Logic Symbol 2 of 5 QW-R502-398.D U74LVC1G126 CMOS IC ABSOLUTE MAXIMUM RATING PARAMETER SYMBOL VCC VIN RATINGS UNIT -0.5 ~ +6.5 V -0.5 ~ +6.5 V Enable mode -0.5 ~ VCC + 0.5 V Output Voltage VOUT Disable mode -0.5 ~ +6.5 V Power-down mode -0.5 ~ +6.5 V VCC or GND Current ICC ±100 mA Continuous Output Current (VOUT=0 to VCC) IOUT ±50 mA Input Clamp Current (VIN<0) IIK -50 mA Output Clamp Current (VOUT>VCC or VOUT<0) IOK ±50 mA SOT-23-5 300 Power Dissipation PD mW SOT-25 360 (TA=-40°C ~ +125°C) SOT-353 250 Operating Temperature TOPR -40 ~ +125 °C Storage Temperature TSTG -65 ~ +150 °C Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. Supply Voltage Input Voltage RECOMMENDED OPERATING CONDITIONS PARAMETER Supply Voltage Input Voltage SYMBOL VCC VIN Output Voltage VOUT Input Transition Rise or Fall Rate t R / tF TEST CONDITIONS Operating VCC=1.65V ~ 5.5V; Enable mode VCC=1.65V ~ 5.5V; Disable mode VCC=0V; Power-Down Mode VCC=1.65V ~ 2.7V VCC=2.7V ~ 5.5V MIN 1.65 0 0 0 0 TYP MAX 5.5 5.5 VCC 5.5 5.5 20 10 UNIT V V V V V ns/V ns/V TYP MAX UNIT V V V V V V V V V V V V V V V V V V V V ELECTRICAL CHARACTERISTICS (TA =25°C , unless otherwise specified) PARAMETER High-Level Input Voltage Low-Level Input Voltage High-Level Output Voltage Low-Level Output Voltage SYMBOL VIH VIL VOH VOL TEST CONDITIONS VCC=1.65V ~ 1.95V VCC=2.3V ~ 2.7V VCC=2.7V ~ 3.6V VCC=4.5V ~ 5.5V VCC=1.65V ~ 1.95V VCC=2.3V ~ 2.7V VCC=2.7V ~ 3.6V VCC=4.5V ~ 5.5V VCC=1.65 ~ 5.5V, IOH=-100μA VCC=1.65V, IOH=-4mA VCC=2.3V, IOH=-8mA VCC=2.7V, IOH=-12mA VCC=3.0V, IOH=-24mA VCC=4.5V, IOH=-32mA VCC=1.65 ~ 5.5V, IOL=100μA VCC=1.65V, IOL=4mA VCC=2.3V, IOL=8mA VCC=2.7V, IOL=12mA VCC=3.0V, IOL=24mA VCC=4.5V, IOL=32mA UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN 0.65×VCC 1.7 2 0.7×VCC 0.35×VCC 0.7 0.8 0.3×VCC VCC-0.1 1.2 1.9 2.2 2.3 3.8 0.1 0.45 0.3 0.4 0.55 0.55 3 of 5 QW-R502-398.D U74LVC1G126 ELECTRICAL CHARACTERISTICS(Cont.) PARAMETER Input Leakage Current Power OFF Leakage Current 3-State Output OFF-State Current Quiescent Supply Current Additional Quiescent Supply Current Per Input Pin CMOS IC SYMBOL II(LEAK) IOFF IOZ ICC ∆ICC TEST CONDITIONS VCC=5.5V, VIN=5.5V or GND VCC=0V, VIN or VOUT=5.5V VCC =5.5V VIN=VIH or VIL, VOUT=VCC or GND VCC=5.5V, VIN=VCC or GND, IOUT=0 MIN VCC=2.3 ~ 5.5V, VIN=VCC-0.6V, IOUT=0 TYP ±0.1 ±0.1 MAX ±5 ±10 UNIT μA μA ±0.1 ±10 μA 0.1 10 μA 5 500 μA TYP 3.0 2.1 2.3 2.0 1.7 3.2 2.2 2.4 2.1 1.6 4.3 2.7 3.4 3.0 2.2 MAX 8.0 5.5 5.5 4.5 4.0 9.4 6.6 6.6 5.3 5.0 9.2 5.5 5.5 5.5 4.2 UNIT ns ns ns ns ns ns ns ns ns ns ns ns ns ns ns SWITCHING CHARACTERISTICS (TA =25°C , unless otherwise specified) PARAMETER SYMBOL Propagation Delay From Input A to Output Y tPLH / tPHL 3-State Output Enable Time From Input OE to Output Y tPZH / tPZL 3-State Output Disable Time From Input OE to Output Y tPLZ / tPLH TEST CONDITIONS VCC=1.8±0.15V, RL=1KΩ CL=30pF VCC=2.5±0.2V, RL=500Ω VCC=2.7V CL=50pF, VCC=3.3±0.3V RL=500Ω VCC=5±0.5V VCC=1.8±0.15V, RL=1KΩ CL=30pF VCC=2.5±0.2V, RL=500Ω VCC=2.7V CL=50pF, VCC=3.3±0.3V RL=500Ω VCC=5±0.5V VCC=1.8±0.15V, RL=1KΩ CL=30pF VCC=2.5±0.2V, RL=500Ω VCC=2.7V CL=50pF, VCC=3.3±0.3V RL=500Ω VCC=5±0.5V UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN 1.0 0.5 0.5 0.5 0.5 1.0 0.5 0.5 0.5 0.5 1.0 0.5 0.5 0.5 0.5 4 of 5 QW-R502-398.D U74LVC1G126 CMOS IC TEST CIRCUIT AND WAVEFORMS S Open GND From Output RL CL 1.8V±0.15V 2.5V±0.2V 2.7V 3.3V±0.3V 5V±0.5V VIN VCC VCC 2.7V 2.7V VCC TEST tPLH/tPHL tPHZ/tPZH tPLZ/tPZL S Open GND VLOAD RL INPUTS VCC VLOAD tR, tF ≤2ns ≤2ns ≤2.5ns ≤2.5ns ≤2.5ns VM VLOAD V∆ CL RL VCC/2 VCC/2 1.5V 1.5V VCC/2 2×VCC 2×VCC 6V 6V 2×VCC 0.15V 0.15V 0.3V 0.3V 0.3V 30pF 30pF 50pF 50pF 50pF 1KΩ 500Ω 500Ω 500Ω 500Ω Notes: 1. CL includes probe and jig capacitance. 2. All input pulses are supplied by generators having the following characteristics: PRR ≤10MHz, ZO = 50Ω. UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 5 of 5 QW-R502-398.D