UNISONIC TECHNOLOGIES CO., LTD DTB123E Preliminary PNP SILICON TRANSISTOR DIGITAL TRANSISTORS (BUILT- IN BIAS RESISTORS) FEATURES * Built-in bias resistors that implies easy ON/OFF applications. * The bias resistors are thin-film resistors with complete isolation to allow positive input. EQUIVALENT CIRCUIT ORDERING INFORMATION Ordering Number Note: DTB123EG-AE3-R Pin assignment: G: GND I: IN DTB123EG-AE3-R Package SOT-23 Pin Assignment 1 2 3 G I O Packing Tape Reel O: OUT (1)Packing Type (1) R: Tape Reel (2)Package Type (2) AE3: SOT-23 (3)Green Package (3) G: Halogen Free and Lead Free MARKING www.unisonic.com.tw Copyright © 2014 Unisonic Technologies Co., Ltd 1 of 3 QW-R225-005.a DTB123E Preliminary PNP SILICON TRANSISTOR ABSOLUTE MAXIMUM RATINGS (TA= 25°C, unless otherwise specified) PARAMETER SYMBOL VCC RATINGS UNIT -50 V -12 V Input Voltage VIN 10 V Output Current IC -500 mA Power Dissipation PD 200 mW Junction Temperature TJ 150 °C Storage Temperature TSTG -55 ~ +150 °C Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. Supply Voltage ELECTRICAL SPECIFICATIONS (TA= 25°C, unless otherwise specified) PARAMETER OFF CHARACTERISTICS Input Voltage SYMBOL VIN(OFF) VIN(ON) VOUT(ON) IIN IOUT(OFF) Output Voltage Input Current Output Current ON CHARACTERISTICS DC Current Gain hFE SMALL SIGNAL CHARACTERISTICS Input Resistance R1 Resistor Ratio R2/R1 Transition Frequency (Note) fT Note: Transition frequency of the device TEST CONDITIONS VCC =-5V, IOUT =-100μA VOUT=-0.3V, IO=-20mA IOUT/IIN=-50mA/-2.5mA VIN=-5V VCC=-50V, VIN=0V VOUT=-5V, IOUT=-50mA VCE =-10V, IE =50mA, f=100MHz TYP MAX -0.5 -3 UNIT V -0.1 -0.3 -3.8 -0.5 V mA μA 2.2 1 200 2.86 1.2 kΩ 39 1.54 0.8 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw MIN MHz 2 of 3 QW-R225-005.a DTB123E Preliminary PNP SILICON TRANSISTOR UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 3 QW-R225-005.a