Note: When ordering the following Housings, order according to the number per box. Accessories for Backplane Systems Daughter board side Rear Side Backplane Housings (for DIN Connectors) Backplane Housing (MIL Flat, Double-row Double-row Type Type) Spacer (available in market) Nut (available in market) No. of contacts Model 32 XC5E-32 64 XC5E-64 No. of contacts 64 Note: The housing can be used only when the board thickness is 2.4 mm. It can be used only when the length of the DIN Fine-fit Connector is 17 mm. Triple-row Type No. of contacts Model 48 XC5G-48 96 (64) XC5G-96 Model XG4A-64A Spacer Backplane (mother board) Fine-fit Connector When using the housing, use the correct spacer for the board as shown below. Backplane housing Backplane Connector Terminal length 2.4-mm board 3.2-mm board 1.6-mm board 13 mm 0.5 mm (See note.) 1.3 mm 17 mm 4.5 mm 3.7 mm 5.3 mm Note: For wrap terminals only. Backplane Lock Lever Backplane lock lever XC6 Connector Housing for backplane (XC5G-96) Lever Base Backplane (mother board) Fine-fit Connector The XC6 Connector with a DIN Connector Cable can be locked with this lock lever. The lock lever also works as a spacer. Terminal length Thickness of of Fine-fit backplane (mm) Connector (mm) Model (See note.) Thickness of spacer base (mm) Securing screw 13 3.0 XC6Z-0001-1 0 M2.6 × 14 13 2.4 XC6Z-0001-2 0.5 M2.6 × 14 13 1.6 XC6Z-0001-3 1.3 M2.6 × 14 17 3.2 XC6Z-0001-4 3.7 M2.6 × 18 17 3.0 XC6Z-0001-5 3.9 M2.6 × 18 17 2.4 XC6Z-0001-6 4.5 M2.6 × 18 17 1.6 XC6Z-0001-7 5.3 M2.6 × 18 Note: A set consists of a pair of levers, bases, screws, and nuts. Fine-fit DIN Connectors with W-shaped Pins XC5 7