XM2Z-0061/0062/0063/0064 Tap Hole Grounding Fixtures

■ Accessories (Sold Separately)
Grounding Fixtures for XM3B
Tap Hole Grounding Fixtures
XM2Z-0061
(With fixed-side tap holes)
XM2Z-0063
(With fixed-side through holes)
Material and Finish
Steel/nickel plated
Lock Pin Grounding Fixtures (for XM3B)
XM2Z-0062
(With fixed-side tap holes)
Material and Finish
Phosphor bronze/nickel plated
XM2Z-0064
Applicable through-hole diameter: 3.2 dia.
(With fixed-side through holes)
Fixed side tap hole
(M3 × 0.5) or through
hole (3.5 dia.)
Fixed side tap hole
(M3 × 0.5) or through
hole (4.0 dia.)
PCB side
M3 × 0.5
Model
XM2Z-0061
XM2Z-0062
XM2Z-0063
XM2Z-0064
Anchors and Grounding Fixtures
Anchor 2 and 3
Anchor
2 or 3
Anchor 1
Connector
Grounding Fixture
(fixed-side tap hole)
Note: Use Grounding Fixtures
XM2Z-0061 or XM2Z-0062.
Anchor 1
Without Anchor
Connector
Grounding
Fixture (fixedside tap hole)
Commercial
screws
Note: 1. Use a 6-mm screw that mates with
the male screw on Anchor 1.
2. Use Grounding Fixtures XM2Z-0063
or XM2Z-0064.
Commercial
screws (M3)
Connector
Commercial
hexagonal
nut (M3)
Note: Always use a screw without
an Anchor. A Grounding Fixture (fixed-side tap) can be
used in place of the hexagonal nut.
Note: 1. Anchor 2 and the following Grounding Fixtures are available: XM3B-@@22-11 and XM3B-@@22-112.
Contact your OMRON representative for other anchor and grounding fixture specifications.
2. 2 anchors are necessary per connector.
D-sub Connectors
XM2/XM3
5