® ® POWERSTAR HQI -T for enclosed fixtures, 1000 and 2000W www.osram.com POWERSTAR® HQI®-T 1000/2000W Technical Information POWERSTAR® HQI®-T 1000/2000W Edition December 3, 2013; replaces edition August 30, 2013. Subject to change without notice. Errors and omissions excepted. Make sure to use the most recent edition. LP HPD MK page 1 of 6 ® ® POWERSTAR HQI -T for enclosed fixtures, 1000 and 2000W General product description ® Metal halide lamp with quartz POWERSTAR technology Tubular & clear outer bulb High luminous flux and efficacy Neutral white N and daylight D Long life time Basic technical description Product reference Nominal lamp wattage Cap Correlated colour temp [W] [K] Comp. Cap. @50hz, cos φ ≈0.9 [μF] Light colour code Length max. (l) Diameter (d) Weight per piece Light centre length (a) Typical Typical lamp lamp voltage1 current1 [mm] [mm] [g] [mm] [V] 76 413.5 220 130 9.0 345 76 412.4 220 130 8.6 430 100 530.3 265 235 8.9 645 430 100 580.0 265 220 9.6 645 430 100 580.0 265 220 9.9 125 641 430 100 580.0 265 116 18.8 60 872 430 100 580.0 265 230 10.3 60 874 430 100 544.0 265 230 10.1 HQI-T 1000W/N 1000 E40 3350 85 633 345 HQI-T 1000W/D 1000 E40 7250 85 872 HQI-T 2000W/N/I 2000 E40 4300 37 643 HQI-T 2000W/N/E SUPER 2000 E40 4550 37 HQI-T 2000W/N/SN SUPER HQI-T 2000W/N 230V 2000 E40 4550 37 2000 E40 4150 HQI-T 2000W/D 2000 E40 7250 HQI-T 2000W/D/I 2000 E40 7450 1 Refers to 50 Hz operation with a reference conventional ballast (IEC 60923). Edition December 3, 2013; replaces edition August 30, 2013. Subject to change without notice. Errors and omissions excepted. Make sure to use the most recent edition. LP HPD MK page 2 of 6 [A] ® ® POWERSTAR HQI -T for enclosed fixtures, 1000 and 2000W Performance specification2 Product reference Rated lamp wattage [W] Rated system wattage3 [W] Luminous flux Luminous efficacy Colour rendering level [lm/W] Colour renderin g index Ra Average life (B50) [h] [lm] HQI-T 1000W/N 1055 n.a. HQI-T 1000W/D 1050 n.a. 110000 104 64 2B 9000 85000 82 81 1B 9000 HQI-T 2000W/N/I 1955 HQI-T 2000W/N/E SUPER 1980 n.a. 200000 102 60 2B 9000 n.a. 245000 124 63 2B 5500 HQI-T 2000W/N/SN SUPER HQI-T 2000W/N 230V 2030 n.a. 240000 118 63 2B 5500 2040 n.a. 190000 93 60 2B 6000 HQI-T 2000W/D 2100 n.a. 180000 85 80 1B 9000 HQI-T 2000W/D/I 2110 n.a. 180000 85 83 1B 9000 Product reference Lamp lumen maintenance factor (LLMF) vs. operation hours 2000h 4000h 6000h 8000h HQI-T 1000W/N 91% 86% 82% 78% HQI-T 1000W/D 71% 58% 47% 35% HQI-T 2000W/N/I 91% 84% 80% 76% HQI-T 2000W/N/E SUPER 79% 66% - - HQI-T 2000W/N/SN SUPER 81% 67% - - HQI-T 2000W/N 230V 95% 90% 85% HQI-T 2000W/D 85% 80% 70% 60% HQI-T 2000W/D/I 86% 75% 67% 60% Product reference Lamp survival factor4 (LSF) vs. operation hours 2000h 4000h 6000h 8000h HQI-T 1000W/N 99% 95% 83% 62% HQI-T 1000W/D 98% 89% 75% 59% HQI-T 2000W/N/I 99% 95% 82% 62% HQI-T 2000W/N/E SUPER 99% 84% - - HQI-T 2000W/N/SN SUPER 99% 84% - - HQI-T 2000W/N 230V 90% 70% 50% HQI-T 2000W/D 98% 89% 75% 58% HQI-T 2000W/D/I 97% 89% 75% 58% 2 The specified values refer to 50 Hz operation with magnetic control gear at rated wattage, unless otherwise stated. They refer to horizontal burning position, in line with IEC 61167. Other burning positions may result in differing values. 3 With OSRAM POWERTRONIC PTi, PT-FIT or PTo 4 Indicates the percentage of operational lamps after a given period of operation time. Edition December 3, 2013; replaces edition August 30, 2013. Subject to change without notice. Errors and omissions excepted. Make sure to use the most recent edition. LP HPD MK page 3 of 6 ® ® POWERSTAR HQI -T for enclosed fixtures, 1000 and 2000W Operation conditions Product reference Burning Max. position permitted outer bulb temperature [°C] Max. permitted base edge temperature [°C] Ignition voltage min. / max.5 Dimming [kV] Required Suitable control OSRAM gear6 electronic control gear HQI-T 1000W/N p30 500 250 4.0 / 5.0 CCG HQI-T 1000W/D p30 500 Not allowed 250 4.0 / 5.0 CCG Not allowed HQI-T 2000W/N/I p30 500 250 internal CCG Not allowed HQI-T 2000W/N/E SUPER p60 500 250 4.0 / 5.0 CCG Not allowed HQI-T 2000W/N/SN SUPER p60 500 250 0.75 / 1.3 CCG Not allowed HQI-T 2000W/N 230V p30 500 250 0.75 / 1.3 CCG Not allowed HQI-T 2000W/D p30 500 250 4.0 / 5.0 CCG Not allowed HQI-T 2000W/D/I p30 500 250 internal CCG Not allowed Safety, materials and environment Product description Typical specific effective radiant UV power [mW/1000 lm] Typical mercury content HQI-T 1000W/N <2 132 HQI-T 1000W/D <2 62 HQI-T 2000W/N/I <2 300 HQI-T 2000W/N/E SUPER <2 220 HQI-T 2000W/N/SN SUPER <2 220 HQI-T 2000W/N 230V <2 130 HQI-T 2000W/D <2 198 HQI-T 2000W/D/I <2 198 [mg] Compliant with safety specifications according to EN 62035 Compliant with RoHS. Only for luminaires with protective shield according to IEC 60598-1 7 For operation with an electromagnetic ballast a protection against rectifying effect at end-of-life required Staring to operating light source to be avoided because of high brightness 5 This limit is for security reasons ECG stands for low frequency square wave electronic ballast. See the respective lamp data sheet in IEC 61167 and Annexes G and H, therein. CCG stands for electromagnetic ballast (see IEC 61347). 7 See IEC 61347. 6 Edition December 3, 2013; replaces edition August 30, 2013. Subject to change without notice. Errors and omissions excepted. Make sure to use the most recent edition. LP HPD MK page 4 of 6 ® ® POWERSTAR HQI -T for enclosed fixtures, 1000 and 2000W Energy labelling8 Product description Energy efficiency class Weighted energy consumption EC [kWh/1000h] HQI-T 1000W/N A+ 1161 HQI-T 1000W/D A 1155 HQI-T 2000W/N/I A+ 2151 HQI-T 2000W/N/E SUPER A+ 2178 HQI-T 2000W/N/SN SUPER A+ 2233 HQI-T 2000W/N 230V A+ 2233 HQI-T 2000W/D A+ 2310 HQI-T 2000W/D/I A 2332 Logistics data Product description ILCOS EAN 10 EAN 40 Standard pack quantity HQI-T 1000W/N MT/UB-1000/633-H/E/SL-E40-76/345/H 4008321528285 4008321528292 6 HQI-T 1000W/D MT/UB-1000/872-H/E/SL-E40-76/345/H 4008321527035 4008321527042 6 HQI-T 2000W/N/I MT/UB-2000/643-E/I/SL-E40-100/430/H 4008321665379 4008321665386 4 HQI-T 2000W/N/E SUPER MT/UB -2000/645-E//E/SL-E40-100/430/H 4008321979063 4008321979070 4 HQI-T 2000W/N/SN SUPER MT/UB -2000/645-E/S/SL-E40-100/430/H 4008321979087 4008321979094 4 HQI-T 2000W/N 230V MT/UB -2000/641-H/S/SL-E40-100/430/H 4008321979100 4008321979117 4 HQI-T 2000W/D MT/UB -2000/872-E/E/SL-E40-100/430/H 4008321526809 4008321526816 4 HQI-T 2000W/D/I MT/UB -2000/874-E/I/SL-E40-100/430/H 4008321527011 4008321527028 4 8 According to Regulation (EU) No 874/2012 of July 12, 2012 Edition December 3, 2013; replaces edition August 30, 2013. Subject to change without notice. Errors and omissions excepted. Make sure to use the most recent edition. LP HPD MK page 5 of 6 ® ® POWERSTAR HQI -T for enclosed fixtures, 1000 and 2000W Typical spectral power distribution Light colour code Fig. no. N 1 D 2 N/E/SUPER 3 N/SN/SUPER 4 Fig 1 Fig 2 Fig 3 Fig 4 References Reference Brochure “Metal halide lamps. Instructions for the use and application” www.osram.com Brochure “High Intensity Discharge lamps. Technical information on reducing the wattage” www.osram.com Ray data (e.g. ASAP, SPEOS, LightTools) available on request 3D data (e.g. Parasolid, STEP) available on request + System guarantee level 3C, see www.osram.com Edition December 3, 2013; replaces edition August 30, 2013. Subject to change without notice. Errors and omissions excepted. Make sure to use the most recent edition. LP HPD MK page 6 of 6